Re: 2.6.20->2.6.21 - networking dies after random time

[Jarek Poplawski <jarkao2@o2.pl>]

On 16-06-2007 23:35, Marcin .lusarz wrote:
> hi
> after upgrading kernel from 2.6.20 to 2.6.21.3 i'm experiencing really
> strange problem - my _both_ network cards dies after random uptime -
> sometimes it's a few minutes, sometimes hours, sometimes it does not
> happen for a couple of days...
> today it happened for the first time without nvidia module and almost
> immediately after system start
> 
> here is the output of some commands which might help debug this:
...
> [   21.726533] Write protecting the kernel read-only data: 1457k
> [   25.734316] ACPI: PCI Interrupt 0000:00:0a.0[A] -> GSI 17 (level,
> low) -> IRQ 17
> [   25.734367] skge 1.10 addr 0xfab00000 irq 17 chip Yukon-Lite rev 9
> [   25.734763] skge eth0: addr 00:11:d8:60:74:55
> [   25.971279] ne2k-pci.c:v1.03 9/22/2003 D. Becker/P. Gortmaker
> [   25.971282]   http://www.scyld.com/network/ne2k-pci.html
> [   25.971364] ACPI: PCI Interrupt 0000:00:0c.0[A] -> GSI 17 (level,
> low) -> IRQ 17
> [   25.971691] eth1: Compex RL2000 found at 0xb000, IRQ 17, 
> 00:80:48:DE:5E:89.
> [   26.888372] Linux video capture interface: v2.00
> [   26.906732] bttv: driver version 0.9.17 loaded
...
> [   31.659572] Adding 1020112k swap on /dev/sda2.  Priority:-1
> extents:1 across:1020112k
> [   42.681974] skge eth1: enabling interface
> [   43.228729] NET: Registered protocol family 17
> [   46.429756] Time: acpi_pm clocksource has been installed.
> [   50.743512] NETDEV WATCHDOG: eth0: transmit timed out
> [   50.743521] eth0: Tx timed out, lost interrupt? TSR=0x3, ISR=0x3, t=574.
...

It looks like skge driver enables different device than probbed.
Maybe you've something old/wrong about eth0/eth1 in /etc configs?
You can also try with netdev= or pci= kernel parameters.
If no result - resend it, please - maybe with some debugging on
(modinfo skge). BTW - netdev seems to be preferred for this.

Regards,
Jarek P.