Hi,

Just got a brand new Dell Vostro and it appears to have an unsupported
Intel network card:

00:19.0 Ethernet controller: Intel Corporation 82562V-2 10/100 Network Connection (rev 02)
	Subsystem: Dell Unknown device 0238
	Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
	Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR-
	Latency: 0
	Interrupt: pin A routed to IRQ 10
	Region 0: Memory at fdfc0000 (32-bit, non-prefetchable) [size=128K]
	Region 1: Memory at fdfff000 (32-bit, non-prefetchable) [size=4K]
	Region 2: I/O ports at fe00 [size=32]
	Capabilities: [c8] Power Management version 2
		Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold+)
		Status: D0 PME-Enable- DSel=0 DScale=1 PME-
	Capabilities: [d0] Message Signalled Interrupts: Mask- 64bit+ Queue=0/0 Enable-
		Address: 0000000000000000  Data: 0000
	Capabilities: [e0] Vendor Specific Information
00: 86 80 c0 10 07 00 10 00 02 00 00 02 00 00 00 00
10: 00 00 fc fd 00 f0 ff fd 01 fe 00 00 00 00 00 00
20: 00 00 00 00 00 00 00 00 00 00 00 00 28 10 38 02
30: 00 00 00 00 c8 00 00 00 00 00 00 00 0a 01 00 00

The e100 driver doesn't recognise it and the "old" eepro100 also
doesn't. Would it be enought to add the PCI ID to one of these drivers
to get the card supported?


Erik

-- 
They're all fools. Don't worry. Darwin may be slow, but he'll
eventually get them. -- Matthew Lammers in alt.sysadmin.recovery