From: "Björn Steinbrink" <B.Steinbrink@gmx.de>
To: Richard Jonsson <richie@coderworld.net>
Cc: linux-kernel@vger.kernel.org, Adrian Bunk <bunk@kernel.org>,
Andreas Mohr <andi@lisas.de>, Ayaz Abdulla <aabdulla@nvidia.com>,
jgarzik@pobox.com, netdev@vger.kernel.org
Subject: [PATCH] Fix forcedeth reversing the MAC address on suspend
Date: Fri, 4 Jan 2008 23:26:33 +0100 [thread overview]
Message-ID: <20080104222633.GA21133@atjola.homenet> (raw)
In-Reply-To: <477E3DEA.4070001@coderworld.net>
For cards that initially have the MAC address stored in reverse order,
the forcedeth driver uses a flag to signal whether the address was
already corrected, so that it is not reversed again on a subsequent
probe.
Unfortunately this flag, which is stored in a register of the card,
seems to get lost during suspend, resulting in the MAC address being
reversed again. To fix that, the MAC address needs to be written back in
reversed order before we suspend and the flag needs to be reset.
The flag is still required because at least kexec will never write back
the reversed address and thus needs to know what state the card is in.
Signed-off-by: Björn Steinbrink <B.Steinbrink@gmx.de>
---
On 2008.01.04 15:08:42 +0100, Richard Jonsson wrote:
> Björn Steinbrink skrev:
>> Richard, could you give this a spin? And then we'd likely need someone
>> to test that with kexec...
>
> The patch you sent does the trick, works fine now, thanks!
> I cannot test this with kexec as I barely know what it is, I'll leave that
> to someone else.
Thanks.
Ayaz, you originally wrote the kexec fix (IIRC), was my analysis of the
problem correct? If so, I'm quite sure that the patch DTRT. Still it
should be tested for the rmmod+modprobe and the kexec case. I'll try to
get my box free for some testing, but that's unlikely in the next few
days. Plus, I've never used kexec myself either. So I'd be grateful if
someone else would step up.
diff --git a/drivers/net/forcedeth.c b/drivers/net/forcedeth.c
index a96583c..f84c752 100644
--- a/drivers/net/forcedeth.c
+++ b/drivers/net/forcedeth.c
@@ -5199,10 +5199,6 @@ static int __devinit nv_probe(struct pci_dev *pci_dev, const struct pci_device_i
dev->dev_addr[3] = (np->orig_mac[0] >> 16) & 0xff;
dev->dev_addr[4] = (np->orig_mac[0] >> 8) & 0xff;
dev->dev_addr[5] = (np->orig_mac[0] >> 0) & 0xff;
- /* set permanent address to be correct aswell */
- np->orig_mac[0] = (dev->dev_addr[0] << 0) + (dev->dev_addr[1] << 8) +
- (dev->dev_addr[2] << 16) + (dev->dev_addr[3] << 24);
- np->orig_mac[1] = (dev->dev_addr[4] << 0) + (dev->dev_addr[5] << 8);
writel(txreg|NVREG_TRANSMITPOLL_MAC_ADDR_REV, base + NvRegTransmitPoll);
}
memcpy(dev->perm_addr, dev->dev_addr, dev->addr_len);
@@ -5414,6 +5410,8 @@ static void __devexit nv_remove(struct pci_dev *pci_dev)
*/
writel(np->orig_mac[0], base + NvRegMacAddrA);
writel(np->orig_mac[1], base + NvRegMacAddrB);
+ writel(readl(base + NvRegTransmitPoll) & ~NVREG_TRANSMITPOLL_MAC_ADDR_REV,
+ base + NvRegTransmitPoll);
/* free all structures */
free_rings(dev);
next prev parent reply other threads:[~2008-01-04 22:26 UTC|newest]
Thread overview: 14+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <477BFC71.7090002@coderworld.net>
[not found] ` <20080102214843.GA19224@rhlx01.hs-esslingen.de>
2008-01-02 23:42 ` forcedeth: MAC-address reversed on resume from suspend Adrian Bunk
2008-01-04 3:43 ` Björn Steinbrink
2008-01-04 8:45 ` Andreas Mohr
2008-01-04 10:17 ` Björn Steinbrink
2008-01-04 22:43 ` Andreas Mohr
2008-01-05 6:10 ` Björn Steinbrink
2008-01-05 6:39 ` Björn Steinbrink
[not found] ` <477E3DEA.4070001@coderworld.net>
2008-01-04 22:26 ` Björn Steinbrink [this message]
2008-01-07 1:47 ` [PATCH] Fix forcedeth reversing the MAC address on suspend Björn Steinbrink
2008-01-06 21:49 ` forcedeth: MAC-address reversed on resume from suspend Adolfo R. Brandes
2008-01-07 1:46 ` Björn Steinbrink
2008-01-07 12:02 ` Adolfo R. Brandes
2008-01-08 7:23 ` David Miller
2008-02-16 9:41 ` Adolfo R. Brandes
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20080104222633.GA21133@atjola.homenet \
--to=b.steinbrink@gmx.de \
--cc=aabdulla@nvidia.com \
--cc=andi@lisas.de \
--cc=bunk@kernel.org \
--cc=jgarzik@pobox.com \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=richie@coderworld.net \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).