Re: vlan 03/07: Add ethtool support

[Ben Hutchings <bhutchings@solarflare.com>]

Patrick McHardy wrote:
> Ben Hutchings wrote:
> >Patrick McHardy wrote:
> >>vlan: Add ethtool support
> >>
> >>Add ethtool support for querying the device for offload settings.
> >>
> >>Signed-off-by: Patrick McHardy <kaber@trash.net>
> >[...]
> >>+static u32 vlan_ethtool_get_rx_csum(struct net_device *dev)
> >>+{
> >>+	const struct vlan_dev_info *vlan = vlan_dev_info(dev);
> >>+	struct net_device *real_dev = vlan->real_dev;
> >>+
> >>+	if (real_dev->ethtool_ops == NULL ||
> >>+	    real_dev->ethtool_ops->get_rx_csum == NULL)
> >>+		return 0;
> >>+	return real_dev->ethtool_ops->get_rx_csum(real_dev);
> >
> >But we don't know whether RX checksum offload applies to VLAN-tagged
> >packets (or, admittedly, any specific protocol).  It would be nice if there
> >was a feature flag for this so it could be advertised in vlan_features.
> 
> True, for now the assumption is that it works for VLANs.
> I don't think that assumption is unreasonable, but I can
> look into a separate flag for this.

I would be surprised if there aren't some NICs that only check frames with
protocol/length set to ETH_P_IP.

> >>+}
> >>+
> >>+static const struct ethtool_ops vlan_ethtool_ops = {
> >>+	.get_link		= ethtool_op_get_link,
> >>+	.get_rx_csum		= vlan_ethtool_get_rx_csum,
> >
> >Can't we also add:
> >
> >	.get_tx_csum		= ethtool_op_get_tx_csum,
> >	.get_sg			= ethtool_op_get_sg,
> >	.get_tso		= ethtool_op_get_tso,
> >	.get_flags		= ethtool_op_get_flags,
> 
> Besides get_flags all of these are handled by default handlers.

So they are.

> What is get_flags used for?

Currently only LRO, but potentially other offload features.

Ben.

-- 
Ben Hutchings, Senior Software Engineer, Solarflare Communications
Not speaking for my employer; that's the marketing department's job.