[PATCH] sky2: Fix suspend/hibernation/shutdown regression with WOL enabled (rev. 2)

["Rafael J. Wysocki" <rjw@sisk.pl>]

On Sunday, 10 of August 2008, Rafael J. Wysocki wrote:
> On Sunday, 10 of August 2008, Stephen Hemminger wrote:
> > On Sat, 9 Aug 2008 23:32:28 +0200
> > "Rafael J. Wysocki" <rjw@sisk.pl> wrote:
> > 
[--snip--]
> > 
> > The problem is not unique to your chip version,
> 
> Well, that's the part I wasn't sure of.
> 
> > so patching out the power down is not the correct solution.
> 
> Sure.

But, shouldn't we switch to page 2 before selecting PHY_MARV_PHY_CTRL?  Things
work correctly if this is done (patch below).

Thanks,
Rafael


---
On my test box with the Asus M3A32-MVP main board there is a
regression from 2.6.26 related to suspend, hibernation and
shutdown.  Namely, if Wake-on-LAN is enabled with
'ethtool -s eth0 wol g', the box hangs solid during all of these
operations, while executing either sky2_suspend(), or
sky2_shutdown().  This patch fixes it for me.

Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
---
 drivers/net/sky2.c |    7 ++++++-
 1 file changed, 6 insertions(+), 1 deletion(-)

Index: linux-2.6/drivers/net/sky2.c
===================================================================
--- linux-2.6.orig/drivers/net/sky2.c
+++ linux-2.6/drivers/net/sky2.c
@@ -666,11 +666,16 @@ static void sky2_phy_power_down(struct s
 
 	if (hw->chip_id != CHIP_ID_YUKON_EC) {
 		if (hw->chip_id == CHIP_ID_YUKON_EC_U) {
-			ctrl = gm_phy_read(hw, port, PHY_MARV_PHY_CTRL);
+			/* select page 2 to access MAC control register */
+			gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 2);
 
+			ctrl = gm_phy_read(hw, port, PHY_MARV_PHY_CTRL);
 			/* enable Power Down */
 			ctrl |= PHY_M_PC_POW_D_ENA;
 			gm_phy_write(hw, port, PHY_MARV_PHY_CTRL, ctrl);
+
+			/* set page register back to 0 */
+			gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 0);
 		}
 
 		/* set IEEE compatible Power Down Mode (dev. #4.99) */