Re: [PATCH 2/3] Adapt the sky2 driver to the reworked PCI PM

["Rafael J. Wysocki" <rjw@sisk.pl>]

On Friday, 15 of August 2008, Rafael J. Wysocki wrote:
> On Friday, 15 of August 2008, Stephen Hemminger wrote:
> > On Thu, 14 Aug 2008 23:38:17 +0200
> > "Rafael J. Wysocki" <rjw@sisk.pl> wrote:
> > 
> > > Adapt the sky2 driver to the reworked PCI PM
> > > 
> > > * Use device_set_wakeup_enable() and friends as needed
> > > * Remove an open-coded reference to the standard PCI PM registers
> > > * Use pci_prepare_to_sleep() and pci_back_from_sleep() in the
> > >   ->suspend() and ->resume() callbacks
> > > * Use the observation that it is sufficient to call pci_enable_wake()
> > >   once, unless it fails
> > > 
> > > Tested on Asus M3A32-MVP (Yukon-2 EC Ultra rev 3).
> > > 
> > > Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
> > > ---
> > >  drivers/net/sky2.c |   34 ++++++++++------------------------
> > >  1 file changed, 10 insertions(+), 24 deletions(-)
> > > 
> > > Index: linux-2.6/drivers/net/sky2.c
> > > ===================================================================
> > > --- linux-2.6.orig/drivers/net/sky2.c
> > > +++ linux-2.6/drivers/net/sky2.c
> > > @@ -3035,7 +3035,8 @@ static int sky2_set_wol(struct net_devic
> > >  	struct sky2_port *sky2 = netdev_priv(dev);
> > >  	struct sky2_hw *hw = sky2->hw;
> > >  
> > > -	if (wol->wolopts & ~sky2_wol_supported(sky2->hw))
> > > +	if ((wol->wolopts & ~sky2_wol_supported(sky2->hw))
> > > +	    || !device_can_wakeup(&hw->pdev->dev))
> > >  		return -EOPNOTSUPP;
> > >  
> > 
> > There was a regression in earlier releases caused because some BIOS's
> > are wrong, and device can wakeup.
> 
> device_can_wakeup() returns 'true' if the device is capable of generating PME#
> from at least one low power state (this is determined on the basis of the
> contents of the device's PCI PM registers - please have a look at
> drivers/pci/pci_pm_init() for details) or if ACPI tells us it can wake up.

drivers/pci/pci.c:pci_pm_init(), sorry.