From: "Matt Carlson" <mcarlson@broadcom.com>
To: "Stephen Hemminger" <shemminger@vyatta.com>
Cc: "David Miller" <davem@davemloft.net>,
"netdev@vger.kernel.org" <netdev@vger.kernel.org>
Subject: Re: [PATCH 30/33] tg3: convert to net_device_ops
Date: Mon, 17 Nov 2008 16:42:57 -0800 [thread overview]
Message-ID: <20081118004257.GA22584@xw6200.broadcom.net> (raw)
In-Reply-To: <20081117234357.345529638@vyatta.com>
On Mon, Nov 17, 2008 at 03:42:37PM -0800, Stephen Hemminger wrote:
> Convert this driver to network device ops.
>
> Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
>
> --- a/drivers/net/tg3.c 2008-11-17 14:03:52.000000000 -0800
> +++ b/drivers/net/tg3.c 2008-11-17 14:45:38.000000000 -0800
> @@ -13343,6 +13343,22 @@ static void __devinit tg3_init_coal(stru
> }
> }
>
> +static const struct net_device_ops tg3_netdev_ops = {
> + .open = tg3_open,
> + .stop = tg3_close,
> + .get_stats = tg3_get_stats,
> + .validate_addr = eth_validate_addr,
> + .set_multicast_list = tg3_set_rx_mode,
> + .set_mac_address = tg3_set_mac_addr,
> + .do_ioctl = tg3_ioctl,
> + .tx_timeout = tg3_tx_timeout,
> + .change_mtu = tg3_change_mtu,
> + .vlan_rx_register = tg3_vlan_rx_register,
> +#ifdef CONFIG_NET_POLL_CONTROLLER
> + .poll_controller = tg3_poll_controller,
> +#endif
> +};
> +
> static int __devinit tg3_init_one(struct pci_dev *pdev,
> const struct pci_device_id *ent)
> {
> @@ -13400,7 +13416,6 @@ static int __devinit tg3_init_one(struct
>
> #if TG3_VLAN_TAG_USED
> dev->features |= NETIF_F_HW_VLAN_TX | NETIF_F_HW_VLAN_RX;
> - dev->vlan_rx_register = tg3_vlan_rx_register;
> #endif
The tg3_vlan_rx_register() function is only defined if
CONFIG_VLAN_8021Q or CONFIG_VLAN_8021Q_MODULE is defined. You will need to
either surround the .vlan_rx_register declaration with TG3_VLAN_TAG_USED or
move the TG3_VLAN_TAG_USED preprocessor guards inside the body of
tg3_vlan_rx_register().
> tp = netdev_priv(dev);
> @@ -13458,21 +13473,11 @@ static int __devinit tg3_init_one(struct
> tp->rx_jumbo_pending = TG3_DEF_RX_JUMBO_RING_PENDING;
> tp->tx_pending = TG3_DEF_TX_RING_PENDING;
>
> - dev->open = tg3_open;
> - dev->stop = tg3_close;
> - dev->get_stats = tg3_get_stats;
> - dev->set_multicast_list = tg3_set_rx_mode;
> - dev->set_mac_address = tg3_set_mac_addr;
> - dev->do_ioctl = tg3_ioctl;
> - dev->tx_timeout = tg3_tx_timeout;
> + dev->netdev_ops = &tg3_netdev_ops;
> netif_napi_add(dev, &tp->napi, tg3_poll, 64);
> dev->ethtool_ops = &tg3_ethtool_ops;
> dev->watchdog_timeo = TG3_TX_TIMEOUT;
> - dev->change_mtu = tg3_change_mtu;
> dev->irq = pdev->irq;
> -#ifdef CONFIG_NET_POLL_CONTROLLER
> - dev->poll_controller = tg3_poll_controller;
> -#endif
>
> err = tg3_get_invariants(tp);
> if (err) {
>
> --
>
> --
> To unsubscribe from this list: send the line "unsubscribe netdev" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
>
next prev parent reply other threads:[~2008-11-18 0:43 UTC|newest]
Thread overview: 93+ messages / expand[flat|nested] mbox.gz Atom feed top
2008-11-17 23:42 [PATCH 00/33] Network Devices Ops (v0.3) Stephen Hemminger
2008-11-17 23:42 ` [PATCH 01/33] netdev: network device operations infrastructure Stephen Hemminger
2008-11-20 5:26 ` David Miller
2008-11-20 5:27 ` David Miller
2008-11-17 23:42 ` [PATCH 02/33] netdev: introduce dev_get_stats() Stephen Hemminger
2008-11-20 5:40 ` David Miller
2008-11-20 9:17 ` Eric Dumazet
2008-11-20 12:27 ` David Miller
2008-11-17 23:42 ` [PATCH 03/33] netdev: expose ethernet address primitives Stephen Hemminger
2008-11-20 5:45 ` David Miller
2008-11-20 6:40 ` David Miller
2008-11-17 23:42 ` [PATCH 04/33] netdev: convert loopback to net_device_ops Stephen Hemminger
2008-11-20 5:46 ` David Miller
2008-11-17 23:42 ` [PATCH 05/33] ifb: convert " Stephen Hemminger
2008-11-20 5:47 ` David Miller
2008-11-17 23:42 ` [PATCH 06/33] dummy: " Stephen Hemminger
2008-11-20 5:48 ` David Miller
2008-11-17 23:42 ` [PATCH 07/33] bridge: " Stephen Hemminger
2008-11-20 5:49 ` David Miller
2008-11-17 23:42 ` [PATCH 08/33] veth: " Stephen Hemminger
2008-11-20 5:50 ` David Miller
2008-11-17 23:42 ` [PATCH 09/33] macvlan: " Stephen Hemminger
2008-11-20 5:51 ` David Miller
2008-11-17 23:42 ` [PATCH 10/33] ip: convert to net_device_ops for ioctl Stephen Hemminger
2008-11-20 5:52 ` David Miller
2008-11-17 23:42 ` [PATCH 11/33] vlan: convert to net_device_ops Stephen Hemminger
2008-11-20 5:54 ` David Miller
2008-11-17 23:42 ` [PATCH 12/33] bonding: " Stephen Hemminger
2008-11-20 5:56 ` David Miller
2008-11-17 23:42 ` [PATCH 13/33] e1000e: " Stephen Hemminger
2008-11-20 5:58 ` David Miller
2008-11-17 23:42 ` [PATCH 14/33] sky2: " Stephen Hemminger
2008-11-18 1:37 ` Stephen Hemminger
2008-11-20 6:00 ` David Miller
2008-11-17 23:42 ` [PATCH 15/33] skge: " Stephen Hemminger
2008-11-20 6:01 ` David Miller
2008-11-17 23:42 ` [PATCH 16/33] r8169: " Stephen Hemminger
2008-11-18 1:38 ` Stephen Hemminger
2008-11-18 21:18 ` Francois Romieu
2008-11-20 6:07 ` David Miller
2008-11-20 19:55 ` Francois Romieu
2008-11-17 23:42 ` [PATCH 17/33] 8139: " Stephen Hemminger
2008-11-18 1:39 ` Stephen Hemminger
2008-11-20 6:09 ` David Miller
2008-11-17 23:42 ` [PATCH 18/33] tun: " Stephen Hemminger
2008-11-20 6:10 ` David Miller
2008-11-17 23:42 ` [PATCH 19/33] atl1e: " Stephen Hemminger
2008-11-20 6:12 ` David Miller
2008-11-17 23:42 ` [PATCH 20/33] atlx: " Stephen Hemminger
2008-11-20 6:14 ` David Miller
2008-11-17 23:42 ` [PATCH 21/33] cxgb3: " Stephen Hemminger
2008-11-20 6:15 ` David Miller
2008-11-17 23:42 ` [PATCH 22/33] cxgb2: " Stephen Hemminger
2008-11-18 1:40 ` Stephen Hemminger
2008-11-20 6:17 ` David Miller
2008-11-17 23:42 ` [PATCH 23/33] e1000: " Stephen Hemminger
2008-11-20 6:18 ` David Miller
2008-11-17 23:42 ` [PATCH 24/33] via-velocity: " Stephen Hemminger
2008-11-20 6:19 ` David Miller
2008-11-17 23:42 ` [PATCH 25/33] igb: " Stephen Hemminger
2008-11-20 6:21 ` David Miller
2008-11-17 23:42 ` [PATCH 26/33] e100: " Stephen Hemminger
2008-11-20 6:22 ` David Miller
2008-11-17 23:42 ` [PATCH 27/33] ppp: " Stephen Hemminger
2008-11-20 6:22 ` David Miller
2008-11-17 23:42 ` [PATCH 28/33] enic: " Stephen Hemminger
2008-11-20 6:23 ` David Miller
2008-11-17 23:42 ` [PATCH 29/33] ixgb: " Stephen Hemminger
2008-11-20 6:24 ` David Miller
2008-11-17 23:42 ` [PATCH 30/33] tg3: " Stephen Hemminger
2008-11-18 0:42 ` Matt Carlson [this message]
2008-11-18 1:37 ` Stephen Hemminger
2008-11-19 21:04 ` Matt Carlson
2008-11-19 21:07 ` Stephen Hemminger
2008-11-20 1:21 ` David Miller
2008-11-20 6:25 ` David Miller
2008-11-17 23:42 ` [PATCH 31/33] forcedeth: " Stephen Hemminger
2008-11-20 6:27 ` David Miller
2008-11-17 23:42 ` [PATCH 32/33] niu: " Stephen Hemminger
2008-11-20 6:28 ` David Miller
2008-11-17 23:42 ` [PATCH 33/33] acenic: " Stephen Hemminger
2008-11-20 6:29 ` David Miller
2008-11-18 1:27 ` [PATCH 00/33] Network Devices Ops (v0.3) Jeff Kirsher
2008-11-18 1:35 ` Stephen Hemminger
2008-11-18 1:43 ` Jeff Kirsher
2008-11-19 21:55 ` Jeff Kirsher
2008-11-19 22:04 ` David Miller
2008-11-20 1:33 ` David Miller
2008-11-20 3:02 ` Stephen Hemminger
2008-11-20 5:21 ` Eric Dumazet
2008-11-20 5:25 ` David Miller
2008-11-20 6:15 ` Alexey Dobriyan
2008-11-20 6:37 ` David Miller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20081118004257.GA22584@xw6200.broadcom.net \
--to=mcarlson@broadcom.com \
--cc=davem@davemloft.net \
--cc=netdev@vger.kernel.org \
--cc=shemminger@vyatta.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).