From: Mathieu Desnoyers <mathieu.desnoyers@polymtl.ca>
To: "Paul E. McKenney" <paulmck@linux.vnet.ibm.com>
Cc: Lai Jiangshan <laijs@cn.fujitsu.com>,
linux-kernel@vger.kernel.org, netdev@vger.kernel.org,
netfilter-devel@vger.kernel.org, mingo@elte.hu,
akpm@linux-foundation.org, torvalds@linux-foundation.org,
davem@davemloft.net, dada1@cosmosbay.com, zbr@ioremap.net,
jeff.chua.linux@gmail.com, paulus@samba.org, jengelh@medozas.de,
r000n@r000n.net, benh@kernel.crashing.org
Subject: Re: [PATCH RFC] v7 expedited "big hammer" RCU grace periods
Date: Tue, 26 May 2009 12:41:29 -0400 [thread overview]
Message-ID: <20090526164129.GA19443@Krystal> (raw)
In-Reply-To: <20090526154625.GA8662@linux.vnet.ibm.com>
* Paul E. McKenney (paulmck@linux.vnet.ibm.com) wrote:
> On Mon, May 25, 2009 at 06:28:43PM -0700, Paul E. McKenney wrote:
> > On Tue, May 26, 2009 at 09:03:55AM +0800, Lai Jiangshan wrote:
> > > Paul E. McKenney wrote:
> > > >
> > > > Good point -- I should at the very least add a comment to
> > > > synchronize_sched_expedited() stating that it cannot be called holding
> > > > any lock that is acquired in a CPU hotplug notifier. If this restriction
> > > > causes any problems, then your approach seems like a promising fix.
> > >
> > > Reviewed-by: Lai Jiangshan <laijs@cn.fujitsu.com>
> >
> > Thank you very much for your review and comments!!!
> >
> > > >> The coupling of synchronize_sched_expedited() and migration_req
> > > >> is largely increased:
> > > >>
> > > >> 1) The offline cpu's per_cpu(rcu_migration_req, cpu) is handled.
> > > >> See migration_call::CPU_DEAD
> > > >
> > > > Good. ;-)
> > > >
> > > >> 2) migration_call() is the highest priority of cpu notifiers,
> > > >> So even any other cpu notifier calls synchronize_sched_expedited(),
> > > >> It'll not cause DEADLOCK.
> > > >
> > > > You mean if using your preempt_disable() approach, right? Unless I am
> > > > missing something, the current get_online_cpus() approach would deadlock
> > > > in this case.
> > >
> > > Yes, I mean if using my preempt_disable() approach. The current
> > > get_online_cpus() approach would NOT deadlock in this case also,
> > > we can require get_online_cpus() in cpu notifiers.
> >
> > I have added the comment for the time being, but should people need to
> > use this in CPU-hotplug notifiers, then again your preempt_disable()
> > approach looks to be a promising fix.
>
> I looked more closely at your preempt_disable() suggestion, which you
> presented earlier as follows:
>
> > I think we can reuse req->dest_cpu and remove get_online_cpus().
> > (and use preempt_disable() and for_each_possible_cpu())
> >
> > req->dest_cpu = -2 means @req is not queued
> > req->dest_cpu = -1 means @req is queued
> >
> > a little like this code:
> >
> > mutex_lock(&rcu_sched_expedited_mutex);
> > for_each_possible_cpu(cpu) {
> > preempt_disable()
> > if (cpu is not online)
> > just set req->dest_cpu to -2;
> > else
> > init and queue req, and wake_up_process().
> > preempt_enable()
> > }
> > for_each_possible_cpu(cpu) {
> > if (req is queued)
> > wait_for_completion().
> > }
> > mutex_unlock(&rcu_sched_expedited_mutex);
>
> I am concerned about the following sequence of events:
>
> o synchronize_sched_expedited() disables preemption, thus blocking
> offlining operations.
>
> o CPU 1 starts offlining CPU 0. It acquires the CPU-hotplug lock,
> and proceeds, and is now waiting for preemption to be enabled.
>
> o synchronize_sched_expedited() disables preemption, sees
> that CPU 0 is online, so initializes and queues a request,
> does a wake-up-process(), and finally does a preempt_enable().
>
> o CPU 0 is currently running a high-priority real-time process,
> so the wakeup does not immediately happen.
>
> o The offlining process completes, including the kthread_stop()
> to the migration task.
>
> o The migration task wakes up, sees kthread_should_stop(),
> and so exits without checking its queue.
>
> o synchronize_sched_expedited() waits forever for CPU 0 to respond.
>
> I suppose that one way to handle this would be to check for the CPU
> going offline before doing the wait_for_completion(), but I am concerned
> about races affecting this check as well.
>
> Or is there something in the CPU-offline process that makes the above
> sequence of events impossible?
>
I think you are right, there is a problem there. The simple fact that
this needs to disable preemption to protect against cpu hotplug seems a
bit strange. If I may propose an alternate solution, which assumes that
threads pinned to a CPU are migrated to a different CPU when a CPU goes
offline (and will therefore execute anyway), and that a CPU brought
online after the first iteration on online cpus was already quiescent
(hopefully my assumptions are right). Preemption is left enabled during
all the critical section.
It looks a lot like Lai's approach, except that I use a cpumask (I
thought it looked cleaner and typically involves less operations than
looping on each possible cpu). I also don't disable preemption and
assume that cpu hotplug can happen at any point during this critical
section.
Something along the lines of :
static DECLARE_BITMAP(cpu_wait_expedited_bits, CONFIG_NR_CPUS);
const struct cpumask *const cpu_wait_expedited_mask =
to_cpumask(cpu_wait_expedited_bits);
mutex_lock(&rcu_sched_expedited_mutex);
cpumask_clear(cpu_wait_expedited_mask);
for_each_online_cpu(cpu) {
init and queue cpu req, and wake_up_process().
cpumask_set_cpu(cpu, cpu_wait_expedited_mask);
}
for_each_cpu_mask(cpu, cpu_wait_expedited_mask) {
wait_for_completion(cpu req);
}
mutex_unlock(&rcu_sched_expedited_mutex);
There is one concern with this approach : if a CPU is hotunplugged and
hotplugged during the critical section, I think the scheduler would
migrate the thread to a different CPU (upon hotunplug) and let the
thread run on this other CPU. If the target CPU is hotplugged again,
this would mean the thread would have run on a different CPU than the
target. I think we can argue that a CPU going offline and online again
will meet quiescent state requirements, so this should not be a problem.
Mathieu
--
Mathieu Desnoyers
OpenPGP key fingerprint: 8CD5 52C3 8E3C 4140 715F BA06 3F25 A8FE 3BAE 9A68
next prev parent reply other threads:[~2009-05-26 16:41 UTC|newest]
Thread overview: 16+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-05-22 19:05 [PATCH RFC] v7 expedited "big hammer" RCU grace periods Paul E. McKenney
2009-05-25 6:35 ` Lai Jiangshan
2009-05-25 16:44 ` Paul E. McKenney
2009-05-26 1:03 ` Lai Jiangshan
2009-05-26 1:28 ` Paul E. McKenney
2009-05-26 15:46 ` Paul E. McKenney
2009-05-26 16:41 ` Mathieu Desnoyers [this message]
2009-05-26 18:13 ` Paul E. McKenney
2009-05-27 1:47 ` Mathieu Desnoyers
2009-05-27 4:27 ` Paul E. McKenney
2009-05-27 14:45 ` Mathieu Desnoyers
2009-05-28 23:52 ` Paul E. McKenney
2009-05-27 1:57 ` Lai Jiangshan
2009-05-27 4:30 ` Paul E. McKenney
2009-05-27 5:37 ` Lai Jiangshan
2009-05-29 0:08 ` Paul E. McKenney
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20090526164129.GA19443@Krystal \
--to=mathieu.desnoyers@polymtl.ca \
--cc=akpm@linux-foundation.org \
--cc=benh@kernel.crashing.org \
--cc=dada1@cosmosbay.com \
--cc=davem@davemloft.net \
--cc=jeff.chua.linux@gmail.com \
--cc=jengelh@medozas.de \
--cc=laijs@cn.fujitsu.com \
--cc=linux-kernel@vger.kernel.org \
--cc=mingo@elte.hu \
--cc=netdev@vger.kernel.org \
--cc=netfilter-devel@vger.kernel.org \
--cc=paulmck@linux.vnet.ibm.com \
--cc=paulus@samba.org \
--cc=r000n@r000n.net \
--cc=torvalds@linux-foundation.org \
--cc=zbr@ioremap.net \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).