[net-2.6 PATCH 2/5] e1000e: increase swflag acquisition timeout for ICHx/PCH

[Jeff Kirsher <jeffrey.t.kirsher@intel.com>]

From: Bruce Allan <bruce.w.allan@intel.com>

In some conditions (e.g. when AMT is enabled on the system), it is possible
to take an extended period of time to for the driver to acquire the sw/fw/hw
hardware semaphore used to protect against concurrent access of a shared
resource (e.g. PHY registers).  This could cause PHY registers to not get
configured properly resulting in link issues.

Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
---

 drivers/net/e1000e/ich8lan.c |    4 +++-
 1 files changed, 3 insertions(+), 1 deletions(-)

diff --git a/drivers/net/e1000e/ich8lan.c b/drivers/net/e1000e/ich8lan.c
index ead6651..fb2222d 100644
--- a/drivers/net/e1000e/ich8lan.c
+++ b/drivers/net/e1000e/ich8lan.c
@@ -122,6 +122,8 @@
 
 #define HV_LED_CONFIG		PHY_REG(768, 30) /* LED Configuration */
 
+#define SW_FLAG_TIMEOUT    1000 /* SW Semaphore flag timeout in milliseconds */
+
 /* ICH GbE Flash Hardware Sequencing Flash Status Register bit breakdown */
 /* Offset 04h HSFSTS */
 union ich8_hws_flash_status {
@@ -599,7 +601,7 @@ static s32 e1000_acquire_swflag_ich8lan(struct e1000_hw *hw)
 		goto out;
 	}
 
-	timeout = PHY_CFG_TIMEOUT * 2;
+	timeout = SW_FLAG_TIMEOUT;
 
 	extcnf_ctrl |= E1000_EXTCNF_CTRL_SWFLAG;
 	ew32(EXTCNF_CTRL, extcnf_ctrl);