From mboxrd@z Thu Jan  1 00:00:00 1970
From: "Michael S. Tsirkin" <mst@redhat.com>
Subject: bnx2: link drops when idle on 2.6.36-rc3
Date: Mon, 6 Sep 2010 13:09:53 +0300
Message-ID: <20100906100932.GA15029@redhat.com>
Mime-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Cc: netdev@vger.kernel.org, eilong@broadcom.com,
	linux-kernel@vger.kernel.org
To: Yaniv Rosner <yaniv.rosner@broadcom.com>,
	Michael Chan <mchan@broadcom.com>
Return-path: <netdev-owner@vger.kernel.org>
Received: from mx1.redhat.com ([209.132.183.28]:61624 "EHLO mx1.redhat.com"
	rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP
	id S1750766Ab0IFKPx (ORCPT <rfc822;netdev@vger.kernel.org>);
	Mon, 6 Sep 2010 06:15:53 -0400
Content-Disposition: inline
Sender: netdev-owner@vger.kernel.org
List-ID: <netdev.vger.kernel.org>

I have an IBM server which after switching to 2.6.36-rc3, started experiencing
link drops, where link would go down apparently at random. The link can be
brought back up without issues.
I started seing this after switching to 2.6.36-rc3.
net-2.6 (0b5d404e349c0236b11466c0a4785520c0be6982) also has this issue,
2.6.34 seems to work fine. Did not try bisecting or testing 2.6.35 yet.
Even log in hardware monitor shows e.g.
  
	SERVPROC 	 05/17/01, 20:13:28 	LAN: Ethernet[0] interface is now active
	SERVPROC 	 05/17/01, 20:09:10 	LAN: Ethernet[0] interface is no longer active
	SERVPROC 	 05/17/01, 19:40:06 	LAN: Ethernet[0] interface is now active
	SERVPROC 	 05/17/01, 19:36:42 	LAN: Ethernet[0] interface is no longer active

The server is mostly idle when this happens.  lspci output for the
device is below.  There appears nothing interesting in dmesg.
I can open a bugzilla at kernel.org if needed, just need to test
2.6.35 first.


04:00.0 Ethernet controller: Broadcom Corporation NetXtreme II BCM5708 Gigabit Ethernet (rev 12)
	Subsystem: IBM Device 0342
	Control: I/O- Mem+ BusMaster+ SpecCycle+ MemWINV+ VGASnoop- ParErr+ Stepping- SERR+ FastB2B- DisINTx+
	Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
	Latency: 64 (16000ns min), Cache Line Size: 64 bytes
	Interrupt: pin A routed to IRQ 51
	Region 0: Memory at c8000000 (64-bit, non-prefetchable) [size=32M]
	Capabilities: [40] PCI-X non-bridge device
		Command: DPERE- ERO- RBC=512 OST=4
		Status: Dev=04:00.0 64bit+ 133MHz+ SCD- USC- DC=simple DMMRBC=512 DMOST=8 DMCRS=32 RSCEM- 266MHz- 533MHz-
	Capabilities: [48] Power Management version 2
		Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot+,D3cold+)
		Status: D0 NoSoftRst- PME-Enable- DSel=0 DScale=1 PME-
	Capabilities: [50] Vital Product Data
		Product Name: Broadcom NetXtreme II Ethernet Controller
		Read-only fields:
			[PN] Part number: BCM95706A0
			[EC] Engineering changes: 220197-2
			[SN] Serial number: 0123456789
			[MN] Manufacture ID: 31 34 65 34
			[RV] Reserved: checksum bad, 30 byte(s) reserved
		End
	Capabilities: [58] MSI: Enable+ Count=1/1 Maskable- 64bit+
		Address: 00000000fee0800c  Data: 41c9
	Kernel driver in use: bnx2
	Kernel modules: bnx2

Thanks!

-- 
MST