[net-next-2.6 RFC PATCH v2 02/13] benet: set ethtool set_phys_id on/off cycle frequency to 1/sec

[Bruce Allan <bruce.w.allan@intel.com>]

Physical identification frequency based on how it was done prior to the
introduction of set_phys_id.  Compile tested only.

Signed-off-by: Bruce Allan <bruce.w.allan@intel.com>
Cc: Sathya Perla <sathya.perla@emulex.com>
Cc: Subbu Seetharaman <subbu.seetharaman@emulex.com>
Cc: Ajit Khaparde <ajit.khaparde@emulex.com>
---

 drivers/net/benet/be_ethtool.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/drivers/net/benet/be_ethtool.c b/drivers/net/benet/be_ethtool.c
index 96f5502..80226e4 100644
--- a/drivers/net/benet/be_ethtool.c
+++ b/drivers/net/benet/be_ethtool.c
@@ -516,7 +516,7 @@ be_set_phys_id(struct net_device *netdev,
 	case ETHTOOL_ID_ACTIVE:
 		be_cmd_get_beacon_state(adapter, adapter->hba_port_num,
 					&adapter->beacon_state);
-		return -EINVAL;
+		return 1;	/* cycle on/off once per second */
 
 	case ETHTOOL_ID_ON:
 		be_cmd_set_beacon_state(adapter, adapter->hba_port_num, 0, 0,