* [PATCH V3 Resend 09/12] net/stmmac: Remove conditional compilation of clk code
[not found] <cover.1336448639.git.viresh.kumar@st.com>
@ 2012-05-08 3:52 ` Viresh Kumar
2012-05-10 1:22 ` David Miller
0 siblings, 1 reply; 2+ messages in thread
From: Viresh Kumar @ 2012-05-08 3:52 UTC (permalink / raw)
To: akpm
Cc: spear-devel, viresh.linux, linux-kernel, linux-arm-kernel,
mturquette, sshtylyov, jgarzik, linux, w.sang, LW, andrew,
Viresh Kumar, Giuseppe Cavallaro, David S. Miller, netdev
With addition of dummy clk_*() calls for non CONFIG_HAVE_CLK cases in clk.h,
there is no need to have clk code enclosed in #ifdef CONFIG_HAVE_CLK, #endif
macros.
This also fixes error paths of probe(), as a goto is required in this patch.
Signed-off-by: Viresh Kumar <viresh.kumar@st.com>
Cc: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Cc: David S. Miller <davem@davemloft.net>
Cc: netdev@vger.kernel.org
---
drivers/net/ethernet/stmicro/stmmac/stmmac.h | 41 ---------------------
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 33 +++++++++--------
2 files changed, 17 insertions(+), 57 deletions(-)
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac.h b/drivers/net/ethernet/stmicro/stmmac/stmmac.h
index db2de9a..7f85895 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac.h
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac.h
@@ -81,9 +81,7 @@ struct stmmac_priv {
struct stmmac_counters mmc;
struct dma_features dma_cap;
int hw_cap_support;
-#ifdef CONFIG_HAVE_CLK
struct clk *stmmac_clk;
-#endif
int clk_csr;
};
@@ -103,42 +101,3 @@ int stmmac_dvr_remove(struct net_device *ndev);
struct stmmac_priv *stmmac_dvr_probe(struct device *device,
struct plat_stmmacenet_data *plat_dat,
void __iomem *addr);
-
-#ifdef CONFIG_HAVE_CLK
-static inline int stmmac_clk_enable(struct stmmac_priv *priv)
-{
- if (!IS_ERR(priv->stmmac_clk))
- return clk_enable(priv->stmmac_clk);
-
- return 0;
-}
-
-static inline void stmmac_clk_disable(struct stmmac_priv *priv)
-{
- if (IS_ERR(priv->stmmac_clk))
- return;
-
- clk_disable(priv->stmmac_clk);
-}
-static inline int stmmac_clk_get(struct stmmac_priv *priv)
-{
- priv->stmmac_clk = clk_get(priv->device, NULL);
-
- if (IS_ERR(priv->stmmac_clk))
- return PTR_ERR(priv->stmmac_clk);
-
- return 0;
-}
-#else
-static inline int stmmac_clk_enable(struct stmmac_priv *priv)
-{
- return 0;
-}
-static inline void stmmac_clk_disable(struct stmmac_priv *priv)
-{
-}
-static inline int stmmac_clk_get(struct stmmac_priv *priv)
-{
- return 0;
-}
-#endif /* CONFIG_HAVE_CLK */
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 1a4cf81..bbdcb55 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -28,6 +28,7 @@
https://bugzilla.stlinux.com/
*******************************************************************************/
+#include <linux/clk.h>
#include <linux/kernel.h>
#include <linux/interrupt.h>
#include <linux/ip.h>
@@ -165,12 +166,8 @@ static void stmmac_verify_args(void)
static void stmmac_clk_csr_set(struct stmmac_priv *priv)
{
-#ifdef CONFIG_HAVE_CLK
u32 clk_rate;
- if (IS_ERR(priv->stmmac_clk))
- return;
-
clk_rate = clk_get_rate(priv->stmmac_clk);
/* Platform provided default clk_csr would be assumed valid
@@ -192,7 +189,6 @@ static void stmmac_clk_csr_set(struct stmmac_priv *priv)
* we can not estimate the proper divider as it is not known
* the frequency of clk_csr_i. So we do not change the default
* divider. */
-#endif
}
#if defined(STMMAC_XMIT_DEBUG) || defined(STMMAC_RX_DEBUG)
@@ -971,7 +967,7 @@ static int stmmac_open(struct net_device *dev)
} else
priv->tm->enable = 1;
#endif
- stmmac_clk_enable(priv);
+ clk_enable(priv->stmmac_clk);
stmmac_check_ether_addr(priv);
@@ -1075,7 +1071,7 @@ open_error:
if (priv->phydev)
phy_disconnect(priv->phydev);
- stmmac_clk_disable(priv);
+ clk_disable(priv->stmmac_clk);
return ret;
}
@@ -1128,7 +1124,7 @@ static int stmmac_release(struct net_device *dev)
#ifdef CONFIG_STMMAC_DEBUG_FS
stmmac_exit_fs();
#endif
- stmmac_clk_disable(priv);
+ clk_disable(priv->stmmac_clk);
return 0;
}
@@ -1922,11 +1918,14 @@ struct stmmac_priv *stmmac_dvr_probe(struct device *device,
ret = register_netdev(ndev);
if (ret) {
pr_err("%s: ERROR %i registering the device\n", __func__, ret);
- goto error;
+ goto error_netdev_register;
}
- if (stmmac_clk_get(priv))
+ priv->stmmac_clk = clk_get(priv->device, NULL);
+ if (IS_ERR(priv->stmmac_clk)) {
pr_warning("%s: warning: cannot get CSR clock\n", __func__);
+ goto error_clk_get;
+ }
/* If a specific clk_csr value is passed from the platform
* this means that the CSR Clock Range selection cannot be
@@ -1944,15 +1943,17 @@ struct stmmac_priv *stmmac_dvr_probe(struct device *device,
if (ret < 0) {
pr_debug("%s: MDIO bus (id: %d) registration failed",
__func__, priv->plat->bus_id);
- goto error;
+ goto error_mdio_register;
}
return priv;
-error:
- netif_napi_del(&priv->napi);
-
+error_mdio_register:
+ clk_put(priv->stmmac_clk);
+error_clk_get:
unregister_netdev(ndev);
+error_netdev_register:
+ netif_napi_del(&priv->napi);
free_netdev(ndev);
return NULL;
@@ -2020,7 +2021,7 @@ int stmmac_suspend(struct net_device *ndev)
else {
stmmac_set_mac(priv->ioaddr, false);
/* Disable clock in case of PWM is off */
- stmmac_clk_disable(priv);
+ clk_disable(priv->stmmac_clk);
}
spin_unlock(&priv->lock);
return 0;
@@ -2044,7 +2045,7 @@ int stmmac_resume(struct net_device *ndev)
priv->hw->mac->pmt(priv->ioaddr, 0);
else
/* enable the clk prevously disabled */
- stmmac_clk_enable(priv);
+ clk_enable(priv->stmmac_clk);
netif_device_attach(ndev);
--
1.7.9
^ permalink raw reply related [flat|nested] 2+ messages in thread