Re: 3.10, iwlwifi 6200AGN: AP changed bandwidth in a way we can't support - disconnect

[Stanislaw Gruszka <sgruszka@redhat.com>]

On Mon, Jul 29, 2013 at 09:34:52AM -0700, Andy Isaacson wrote:
> After upgrading to 3.10.4 and traveling to Europe I'm often suffering
> from failures to associate with the following in dmesg:
> 
> [   37.351621] wlan0: authenticate with 64:70:02:e6:a6:ba
> [   37.364701] wlan0: send auth to 64:70:02:e6:a6:ba (try 1/3)
> [   37.366358] wlan0: authenticated
> [   37.368543] wlan0: associate with 64:70:02:e6:a6:ba (try 1/3)
> [   37.372765] wlan0: RX AssocResp from 64:70:02:e6:a6:ba (capab=0x431 status=0 aid=8)
> [   37.380190] wlan0: associated
> [   37.438935] wlan0: AP 64:70:02:e6:a6:ba changed bandwidth, new config is 2447 MHz, width 1 (2447/0 MHz)
> [   37.438941] wlan0: AP 64:70:02:e6:a6:ba changed bandwidth in a way we can't support - disconnect
> 
> I hacked the driver to do
> 
> -                  "AP %pM changed bandwidth, new config is %d MHz, width %d (%d/%d MHz)\n",
> +                  "AP %pM changed bandwidth, new config is %d MHz, width %d (%d/%d MHz) flags %x/%x\n",
>                    ifmgd->bssid, chandef.chan->center_freq, chandef.width,
> -                  chandef.center_freq1, chandef.center_freq2);
> +                  chandef.center_freq1, chandef.center_freq2, flags, ifmgd->flags);
> 
> and
> 
> -       if (flags != (ifmgd->flags & (IEEE80211_STA_DISABLE_HT |
> +       if ((flags != 0x810 && ifmgd->flags != 0x804) && (
> +            flags != (ifmgd->flags & (IEEE80211_STA_DISABLE_HT |
> 
> and the result is a working link with

We have few reports about this. Johannes, proposed this patch
http://p.sipsolutions.net/9d1dd0734d2c3a7a.txt

Could you check if it fixes the problem for you?

Stanislaw