From: Veaceslav Falico <vfalico@redhat.com>
To: rama nichanamatlu <rama.nichanamatlu@oracle.com>
Cc: netdev@vger.kernel.org
Subject: Re: [PATCH] bonding: If IP route look-up to send an ARP fails, mark in bonding structure as no ARP sent.
Date: Thu, 21 Nov 2013 12:10:22 +0100 [thread overview]
Message-ID: <20131121111022.GA30998@redhat.com> (raw)
In-Reply-To: <528D5980.3040309@oracle.com>
On Wed, Nov 20, 2013 at 04:53:20PM -0800, rama nichanamatlu wrote:
>During the creation of VLAN's atop bonding the underlying interfaces
>are made part of VLAN's, and at the same bonding driver gets aware
>that VLAN's exists above it and hence would consult IP routing for
>every ARP to be sent to determine the route which tells bonding
>driver the correct VLAN tag to attach to the outgoing ARP packet.
>But, during the VLAN creation when vlan driver puts the underlying
>interface into default vlan and then actual vlan, in-between this if
>bonding driver consults the IP for a route, IP fails to provide a
>correct route and upon which bonding driver drops the ARP packet. ARP
>monitor when it
>comes around next time, sees no ARP response and fails-over to the
>next available slave. Consulting for a IP route,
>ip_route_output(),happens in bond_arp_send_all().
bonding works as expected - nothing to fix here. And even as a
workaround/hack - I'm not sure we need that to suppress one failover *only*
when vlan is added on top.
>
>To prevent this false fail-over, when bonding driver fails to send an
>ARP out it marks in its private structure, bonding{}, not to expect
>an ARP response, when ARP monitor comes around next time ARP sending
>will be tried again.
>
>Extensively tested in a VM environment; sr-iov intf->bonding
>intf->vlan intf. All virtual interfaces created at boot time.
>
>Orabug: 17172660
>Signed-off-by: Venkat Venkatsubra <venkat.x.venkatsubra@oracle.com>
>Signed-off-by: Rama Nichanamatlu <rama.nichanamatlu@oracle.com>
>---
> drivers/net/bonding/bond_main.c | 13 ++++++++-----
> drivers/net/bonding/bonding.h | 1 +
> 2 files changed, 9 insertions(+), 5 deletions(-)
>
>diff --git a/drivers/net/bonding/bond_main.c
>b/drivers/net/bonding/bond_main.c
>index dde6b4a..d475161 100644
>--- a/drivers/net/bonding/bond_main.c
>+++ b/drivers/net/bonding/bond_main.c
>@@ -2661,7 +2661,7 @@ static int bond_has_this_ip(struct bonding
>*bond, __be32 ip)
> * switches in VLAN mode (especially if ports are configured as
> * "native" to a VLAN) might not pass non-tagged frames.
> */
>-static void bond_arp_send(struct net_device *slave_dev, int arp_op,
>__be32 dest_ip, __be32 src_ip, unsigned short vlan_id)
>+static void bond_arp_send(struct bonding *bond, struct net_device
>*slave_dev, int arp_op, __be32 dest_ip, __be32 src_ip, unsigned short
>vlan_id)
> {
> struct sk_buff *skb;
> @@ -2683,6 +2683,7 @@ static void bond_arp_send(struct net_device
>*slave_dev, int arp_op, __be32 dest_
> }
> }
> arp_xmit(skb);
>+ bond->arp_sent=true;
> }
> @@ -2700,7 +2701,7 @@ static void bond_arp_send_all(struct bonding
>*bond, struct slave *slave)
> pr_debug("basa: target %x\n", targets[i]);
> if (!bond->vlgrp) {
> pr_debug("basa: empty vlan: arp_send\n");
>- bond_arp_send(slave->dev, ARPOP_REQUEST, targets[i],
>+ bond_arp_send(bond, slave->dev, ARPOP_REQUEST, targets[i],
> bond->master_ip, 0);
> continue;
> }
>@@ -2726,7 +2727,7 @@ static void bond_arp_send_all(struct bonding
>*bond, struct slave *slave)
> if (rt->dst.dev == bond->dev) {
> ip_rt_put(rt);
> pr_debug("basa: rtdev == bond->dev: arp_send\n");
>- bond_arp_send(slave->dev, ARPOP_REQUEST, targets[i],
>+ bond_arp_send(bond, slave->dev, ARPOP_REQUEST, targets[i],
> bond->master_ip, 0);
> continue;
> }
>@@ -2744,7 +2745,7 @@ static void bond_arp_send_all(struct bonding
>*bond, struct slave *slave)
> if (vlan_id) {
> ip_rt_put(rt);
>- bond_arp_send(slave->dev, ARPOP_REQUEST, targets[i],
>+ bond_arp_send(bond, slave->dev, ARPOP_REQUEST, targets[i],
> vlan->vlan_ip, vlan_id);
> continue;
> }
>@@ -3206,7 +3207,7 @@ void bond_activebackup_arp_mon(struct
>work_struct *work)
> should_notify_peers = bond_should_notify_peers(bond);
> - if (bond_ab_arp_inspect(bond, delta_in_ticks)) {
>+ if (bond->arp_sent && bond_ab_arp_inspect(bond, delta_in_ticks)) {
> read_unlock(&bond->lock);
> rtnl_lock();
> read_lock(&bond->lock);
>@@ -3218,6 +3219,7 @@ void bond_activebackup_arp_mon(struct
>work_struct *work)
> read_lock(&bond->lock);
> }
> + bond->arp_sent=false;
> bond_ab_arp_probe(bond);
> re_arm:
>@@ -4425,6 +4427,7 @@ static void bond_setup(struct net_device *bond_dev)
> bond_dev->hw_features &= ~(NETIF_F_ALL_CSUM & ~NETIF_F_NO_CSUM);
> bond_dev->features |= bond_dev->hw_features;
>+ bond->arp_sent=false;
> }
> static void bond_work_cancel_all(struct bonding *bond)
>diff --git a/drivers/net/bonding/bonding.h b/drivers/net/bonding/bonding.h
>index e9a3c56..3878bbd 100644
>--- a/drivers/net/bonding/bonding.h
>+++ b/drivers/net/bonding/bonding.h
>@@ -253,6 +253,7 @@ struct bonding {
> /* debugging suport via debugfs */
> struct dentry *debug_dir;
> #endif /* CONFIG_DEBUG_FS */
>+ bool arp_sent;
> };
> #define bond_slave_get_rcu(dev) \
>--
>1.8.2.1
>
next prev parent reply other threads:[~2013-11-21 11:12 UTC|newest]
Thread overview: 13+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-11-21 0:53 [PATCH] bonding: If IP route look-up to send an ARP fails, mark in bonding structure as no ARP sent rama nichanamatlu
2013-11-21 1:10 ` Ding Tianhong
2013-11-21 1:18 ` Jay Vosburgh
2013-11-21 2:23 ` rama nichanamatlu
2013-11-21 6:01 ` rama nichanamatlu
2013-11-21 11:10 ` Veaceslav Falico [this message]
2013-11-21 20:34 ` rama nichanamatlu
2013-11-21 21:12 ` Jay Vosburgh
2013-11-22 0:34 ` rama nichanamatlu
2013-11-22 2:43 ` Jay Vosburgh
2013-11-22 8:28 ` rama nichanamatlu
-- strict thread matches above, loose matches on Subject: below --
2013-11-21 1:36 rama nichanamatlu
[not found] <528D5DF7.6060103@oracle.com>
2013-11-21 1:40 ` rama nichanamatlu
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20131121111022.GA30998@redhat.com \
--to=vfalico@redhat.com \
--cc=netdev@vger.kernel.org \
--cc=rama.nichanamatlu@oracle.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).