Re: [RFC PATCH 4/5] mlx4: add support for fast rx drop bpf program

[Brenden Blanco <bblanco@plumgrid.com>]

On Sat, Apr 02, 2016 at 10:23:31AM +0200, Jesper Dangaard Brouer wrote:
[...]
> 
> I think you need to DMA sync RX-page before you can safely access
> packet data in page (on all arch's).
> 
Thanks, I will give that a try in the next spin.
> > +			ethh = (struct ethhdr *)(page_address(frags[0].page) +
> > +						 frags[0].page_offset);
> > +			if (mlx4_call_bpf(prog, ethh, length)) {
> 
> AFAIK length here covers all the frags[n].page, thus potentially
> causing the BPF program to access memory out of bound (crash).
> 
> Having several page fragments is AFAIK an optimization for jumbo-frames
> on PowerPC (which is a bit annoying for you use-case ;-)).
> 
Yeah, this needs some more work. I can think of some options:
1. limit pseudo skb.len to first frag's length only, and signal to
program that the packet is incomplete
2. for nfrags>1 skip bpf processing, but this could be functionally
incorrect for some use cases
3. run the program for each frag
4. reject ndo_bpf_set when frags are possible (large mtu?)

My preference is to go with 1, thoughts?
> 
[...]