[PATCH v4 3/4] dt-bindings: can: m_can: Document new can transceiver binding

[Franklin S Cooper Jr <fcooper@ti.com>]

Add information regarding can-transceiver binding. This is especially
important for MCAN since the IP allows CAN FD mode to run significantly
faster than what most transceivers are capable of.

Signed-off-by: Franklin S Cooper Jr <fcooper@ti.com>
---
Drop unit address.
Switch from using fixed-transceiver to can-transceiver
Indicate that can-transceiver is an optional subnode not a property.

 Documentation/devicetree/bindings/net/can/m_can.txt | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/can/m_can.txt b/Documentation/devicetree/bindings/net/can/m_can.txt
index 9e33177..ee90aac 100644
--- a/Documentation/devicetree/bindings/net/can/m_can.txt
+++ b/Documentation/devicetree/bindings/net/can/m_can.txt
@@ -43,6 +43,11 @@ Required properties:
 			  Please refer to 2.4.1 Message RAM Configuration in
 			  Bosch M_CAN user manual for details.
 
+Optional Subnode:
+- can-transceiver	: Can-transceiver subnode describing maximum speed
+			  that can be used for CAN/CAN-FD modes. See
+			  Documentation/devicetree/bindings/net/can/can-transceiver.txt
+			  for details.
 Example:
 SoC dtsi:
 m_can1: can@020e8000 {
@@ -64,4 +69,8 @@ Board dts:
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_m_can1>;
 	status = "enabled";
+
+	can-transceiver@ {
+		max-bitrate = <5000000>;
+	};
 };
-- 
2.9.4.dirty