From mboxrd@z Thu Jan  1 00:00:00 1970
From: Andrew Lunn <andrew@lunn.ch>
Subject: Re: [PATCH] phy: realtek: use new helpers for paged register access
Date: Fri, 12 Jan 2018 22:01:07 +0100
Message-ID: <20180112210107.GA7470@lunn.ch>
References: <ac76cb9b-f834-96a5-80f4-3c6225fd037f@gmail.com>
Mime-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Cc: Florian Fainelli <f.fainelli@gmail.com>,
        "netdev@vger.kernel.org" <netdev@vger.kernel.org>
To: Heiner Kallweit <hkallweit1@gmail.com>
Return-path: <netdev-owner@vger.kernel.org>
Received: from vps0.lunn.ch ([185.16.172.187]:42348 "EHLO vps0.lunn.ch"
        rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP
        id S964844AbeALVBI (ORCPT <rfc822;netdev@vger.kernel.org>);
        Fri, 12 Jan 2018 16:01:08 -0500
Content-Disposition: inline
In-Reply-To: <ac76cb9b-f834-96a5-80f4-3c6225fd037f@gmail.com>
Sender: netdev-owner@vger.kernel.org
List-ID: <netdev.vger.kernel.org>

On Fri, Jan 12, 2018 at 09:30:08PM +0100, Heiner Kallweit wrote:
> Make use of the new helpers for paged register access.
> 
> Signed-off-by: Heiner Kallweit <hkallweit1@gmail.com>
> ---
>  drivers/net/phy/realtek.c | 59 +++++++++++------------------------------------
>  1 file changed, 14 insertions(+), 45 deletions(-)
> 
> diff --git a/drivers/net/phy/realtek.c b/drivers/net/phy/realtek.c
> index 7c1bf688d..887bad07a 100644
> --- a/drivers/net/phy/realtek.c
> +++ b/drivers/net/phy/realtek.c
> @@ -41,37 +41,14 @@ MODULE_DESCRIPTION("Realtek PHY driver");
>  MODULE_AUTHOR("Johnson Leung");
>  MODULE_LICENSE("GPL");
>  
> -static int rtl8211x_page_read(struct phy_device *phydev, u16 page, u16 address)
> +static int rtl821x_read_page(struct phy_device *phydev)
>  {
> -	int ret;
> -
> -	ret = phy_write(phydev, RTL821x_PAGE_SELECT, page);
> -	if (ret)
> -		return ret;
> -
> -	ret = phy_read(phydev, address);
> -
> -	/* restore to default page 0 */
> -	phy_write(phydev, RTL821x_PAGE_SELECT, 0x0);
> -
> -	return ret;
> +	return phy_read(phydev, RTL821x_PAGE_SELECT);

Hi Heiner

It think this is wrong. You need to use __phy_read(). phy_read() does
an mdiobus_read(), which takes the bus->mdio_lock. However,

int phy_save_page(struct phy_device *phydev)
{
        mutex_lock(&phydev->mdio.bus->mdio_lock);
        return __phy_read_page(phydev);
}

This also takes the same lock. So this should deadlock.

Try turning on CONFIG_PROVE_LOCKING, it will detect problems like
this.

	Andrew