From mboxrd@z Thu Jan 1 00:00:00 1970 From: Richard Cochran Subject: Re: [PATCH RFC net-next] igb: adjust SYSTIM register using TIMADJ register Date: Fri, 20 Apr 2018 14:12:10 -0700 Message-ID: <20180420211210.43oyqmqoho6gdnfh@localhost> References: <1524254196-21705-1-git-send-email-kshitiz.gupta@ni.com> Mime-Version: 1.0 Content-Type: text/plain; charset=us-ascii Cc: jeffrey.t.kirsher@intel.com, intel-wired-lan@lists.osuosl.org, netdev@vger.kernel.org, linux-kernel@vger.kernel.org To: Kshitiz Gupta Return-path: Content-Disposition: inline In-Reply-To: <1524254196-21705-1-git-send-email-kshitiz.gupta@ni.com> Sender: linux-kernel-owner@vger.kernel.org List-Id: netdev.vger.kernel.org On Fri, Apr 20, 2018 at 02:56:36PM -0500, Kshitiz Gupta wrote: > Currently the driver adjusts time by reading the current time and then > modifying it before writing to SYSTIM register. This can introduce > inaccuracies in SYSTIM. With a PREEMPT_RT kernel, spinlocks may be > interrupted, which in the existing implementation may lead to increased > time between the read and the write. > > Alternatively as per section 7.8.3.2 in the i210 data sheet, this > operation can be done more accurately by using the TIMADJ registers, > but this should only be used for adjustments less than one 8th of the > sync interval. Once this register is written, the software can poll on > TSICR.TADJ to make sure that adjustment operation is completed. I doubt the utility of this. The first jump is typically to correct a large offset of seconds, minutes, or even months. After that, the servo corrects any remaining error. It would help if you would show us a clearly improved servo response with this change applied. Thanks, Richard