From mboxrd@z Thu Jan 1 00:00:00 1970 From: Christian Lamparter Subject: [PATCH] net: emac: fix fixed-link setup for the RTL8363SB switch Date: Mon, 17 Sep 2018 17:22:40 +0200 Message-ID: <20180917152240.18177-1-chunkeey@gmail.com> Mime-Version: 1.0 Content-Transfer-Encoding: 8bit Cc: Ivan Mikhaylov , "David S . Miller" To: netdev@vger.kernel.org Return-path: Received: from mail-wm1-f67.google.com ([209.85.128.67]:54247 "EHLO mail-wm1-f67.google.com" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S1728820AbeIQUuc (ORCPT ); Mon, 17 Sep 2018 16:50:32 -0400 Received: by mail-wm1-f67.google.com with SMTP id b19-v6so10122865wme.3 for ; Mon, 17 Sep 2018 08:22:43 -0700 (PDT) Sender: netdev-owner@vger.kernel.org List-ID: On the Netgear WNDAP620, the emac ethernet isn't receiving nor xmitting any frames from/to the RTL8363SB (identifies itself as a RTL8367RB). This is caused by the emac hardware not knowing the forced link parameters for speed, duplex, pause, etc. This begs the question, how this was working on the original driver code, when it was necessary to set the phy_address and phy_map to 0xffffffff. But I guess without access to the old PPC405/440/460 hardware, it's not possible to know. Signed-off-by: Christian Lamparter --- drivers/net/ethernet/ibm/emac/core.c | 15 ++++++++++----- 1 file changed, 10 insertions(+), 5 deletions(-) diff --git a/drivers/net/ethernet/ibm/emac/core.c b/drivers/net/ethernet/ibm/emac/core.c index 354c0982847b..3b398ebdb5e6 100644 --- a/drivers/net/ethernet/ibm/emac/core.c +++ b/drivers/net/ethernet/ibm/emac/core.c @@ -2677,12 +2677,17 @@ static int emac_init_phy(struct emac_instance *dev) if (of_phy_is_fixed_link(np)) { int res = emac_dt_mdio_probe(dev); - if (!res) { - res = of_phy_register_fixed_link(np); - if (res) - mdiobus_unregister(dev->mii_bus); + if (res) + return res; + + res = of_phy_register_fixed_link(np); + dev->phy_dev = of_phy_find_device(np); + if (res || !dev->phy_dev) { + mdiobus_unregister(dev->mii_bus); + return res ? res : -EINVAL; } - return res; + emac_adjust_link(dev->ndev); + put_device(&dev->phy_dev->mdio.dev); } return 0; } -- 2.19.0.rc2