netdev.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Sasha Levin <sashal@kernel.org>
To: linux-kernel@vger.kernel.org, stable@vger.kernel.org
Cc: Thierry Reding <treding@nvidia.com>,
	"David S . Miller" <davem@davemloft.net>,
	Sasha Levin <sashal@kernel.org>,
	netdev@vger.kernel.org
Subject: [PATCH AUTOSEL 4.19 20/73] net: stmmac: Move debugfs init/exit to ->probe()/->remove()
Date: Wed, 12 Dec 2018 23:27:45 -0500	[thread overview]
Message-ID: <20181213042838.75160-20-sashal@kernel.org> (raw)
In-Reply-To: <20181213042838.75160-1-sashal@kernel.org>

From: Thierry Reding <treding@nvidia.com>

[ Upstream commit 5f2b8b62786853341a20d4cd4948f9cbca3db002 ]

Setting up and tearing down debugfs is current unbalanced, as seen by
this error during resume from suspend:

    [  752.134067] dwc-eth-dwmac 2490000.ethernet eth0: ERROR failed to create debugfs directory
    [  752.134347] dwc-eth-dwmac 2490000.ethernet eth0: stmmac_hw_setup: failed debugFS registration

The imbalance happens because the driver creates the debugfs hierarchy
when the device is opened and tears it down when the device is closed.
There's little gain in that, and it could be argued that it is even
surprising because it's not usually done for other devices. Fix the
imbalance by moving the debugfs creation and teardown to the driver's
->probe() and ->remove() implementations instead.

Note that the ring descriptors cannot be read while the interface is
down, so make sure to return an empty file when the descriptors_status
debugfs file is read.

Signed-off-by: Thierry Reding <treding@nvidia.com>
Acked-by: Jose Abreu <joabreu@synopsys.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 .../net/ethernet/stmicro/stmmac/stmmac_main.c | 23 +++++++++++--------
 1 file changed, 13 insertions(+), 10 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 75896d6ba6e2..99ea5c4ce29c 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -2547,12 +2547,6 @@ static int stmmac_hw_setup(struct net_device *dev, bool init_ptp)
 			netdev_warn(priv->dev, "PTP init failed\n");
 	}
 
-#ifdef CONFIG_DEBUG_FS
-	ret = stmmac_init_fs(dev);
-	if (ret < 0)
-		netdev_warn(priv->dev, "%s: failed debugFS registration\n",
-			    __func__);
-#endif
 	priv->tx_lpi_timer = STMMAC_DEFAULT_TWT_LS;
 
 	if (priv->use_riwt) {
@@ -2753,10 +2747,6 @@ static int stmmac_release(struct net_device *dev)
 
 	netif_carrier_off(dev);
 
-#ifdef CONFIG_DEBUG_FS
-	stmmac_exit_fs(dev);
-#endif
-
 	stmmac_release_ptp(priv);
 
 	return 0;
@@ -3896,6 +3886,9 @@ static int stmmac_sysfs_ring_read(struct seq_file *seq, void *v)
 	u32 tx_count = priv->plat->tx_queues_to_use;
 	u32 queue;
 
+	if ((dev->flags & IFF_UP) == 0)
+		return 0;
+
 	for (queue = 0; queue < rx_count; queue++) {
 		struct stmmac_rx_queue *rx_q = &priv->rx_queue[queue];
 
@@ -4394,6 +4387,13 @@ int stmmac_dvr_probe(struct device *device,
 		goto error_netdev_register;
 	}
 
+#ifdef CONFIG_DEBUG_FS
+	ret = stmmac_init_fs(ndev);
+	if (ret < 0)
+		netdev_warn(priv->dev, "%s: failed debugFS registration\n",
+			    __func__);
+#endif
+
 	return ret;
 
 error_netdev_register:
@@ -4429,6 +4429,9 @@ int stmmac_dvr_remove(struct device *dev)
 
 	netdev_info(priv->dev, "%s: removing driver", __func__);
 
+#ifdef CONFIG_DEBUG_FS
+	stmmac_exit_fs(ndev);
+#endif
 	stmmac_stop_all_dma(priv);
 
 	stmmac_mac_set(priv, priv->ioaddr, false);
-- 
2.19.1

  parent reply	other threads:[~2018-12-13  4:27 UTC|newest]

Thread overview: 32+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2018-12-13  4:27 [PATCH AUTOSEL 4.19 01/73] mac80211_hwsim: fix module init error paths for netlink Sasha Levin
2018-12-13  4:27 ` [PATCH AUTOSEL 4.19 06/73] tools/bpf: fix two test_btf unit test cases Sasha Levin
2018-12-13  4:27 ` [PATCH AUTOSEL 4.19 07/73] tools/bpf: add addition type tests to test_btf Sasha Levin
2018-12-13  4:27 ` [PATCH AUTOSEL 4.19 08/73] net: ethernet: ave: Replace NET_IP_ALIGN with AVE_FRAME_HEADROOM Sasha Levin
2018-12-13  4:27 ` [PATCH AUTOSEL 4.19 09/73] net: phy: sfp: correct store of detected link modes Sasha Levin
2018-12-13  4:27 ` Sasha Levin [this message]
2018-12-13  4:27 ` [PATCH AUTOSEL 4.19 21/73] net: aquantia: fix rx checksum offload bits Sasha Levin
2018-12-13  4:27 ` [PATCH AUTOSEL 4.19 22/73] bonding: fix 802.3ad state sent to partner when unbinding slave Sasha Levin
2018-12-13  4:27 ` [PATCH AUTOSEL 4.19 23/73] bpf: Fix verifier log string check for bad alignment Sasha Levin
2018-12-13  4:27 ` [PATCH AUTOSEL 4.19 24/73] liquidio: read sc->iq_no before release sc Sasha Levin
2018-12-13  4:27 ` [PATCH AUTOSEL 4.19 26/73] SUNRPC: Fix leak of krb5p encode pages Sasha Levin
2018-12-13  4:27 ` [PATCH AUTOSEL 4.19 27/73] SUNRPC: Fix a potential race in xprt_connect() Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 42/73] net: phy: don't allow __set_phy_supported to add unsupported modes Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 43/73] net: 8139cp: fix a BUG triggered by changing mtu with network traffic Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 44/73] net: phy: Fix not to call phy_resume() if PHY is not attached Sasha Levin
2018-12-13  4:48   ` Yoshihiro Shimoda
2018-12-19 13:43     ` Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 45/73] net: phy: micrel: add toggling phy reset " Sasha Levin
2018-12-13  4:44   ` Yoshihiro Shimoda
2018-12-19 13:43     ` Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 46/73] macvlan: return correct error value Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 47/73] mv88e6060: disable hardware level MAC learning Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 48/73] net/mlx4_en: Change min MTU size to ETH_MIN_MTU Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 49/73] net/mlx4_en: Fix build break when CONFIG_INET is off Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 50/73] bpf: check pending signals while verifying programs Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 54/73] ethernet: fman: fix wrong of_node_put() in probe function Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 56/73] net: mvpp2: fix detection of 10G SFP modules Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 57/73] net: mvpp2: fix phylink handling of invalid PHY modes Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 64/73] vhost/vsock: fix reset orphans race with close timeout Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 65/73] mlxsw: spectrum_switchdev: Fix VLAN device deletion via ioctl Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 72/73] Revert "net/ibm/emac: wrong bit is used for STA control" Sasha Levin
2018-12-13  4:28 ` [PATCH AUTOSEL 4.19 73/73] net/mlx4_core: Correctly set PFC param if global pause is turned off Sasha Levin

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20181213042838.75160-20-sashal@kernel.org \
    --to=sashal@kernel.org \
    --cc=davem@davemloft.net \
    --cc=linux-kernel@vger.kernel.org \
    --cc=netdev@vger.kernel.org \
    --cc=stable@vger.kernel.org \
    --cc=treding@nvidia.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).