From: Sasha Levin <sashal@kernel.org>
To: linux-kernel@vger.kernel.org, stable@vger.kernel.org
Cc: Kunihiko Hayashi <hayashi.kunihiko@socionext.com>,
"David S . Miller" <davem@davemloft.net>,
Sasha Levin <sashal@kernel.org>,
netdev@vger.kernel.org
Subject: [PATCH AUTOSEL 4.19 08/73] net: ethernet: ave: Replace NET_IP_ALIGN with AVE_FRAME_HEADROOM
Date: Wed, 12 Dec 2018 23:27:33 -0500 [thread overview]
Message-ID: <20181213042838.75160-8-sashal@kernel.org> (raw)
In-Reply-To: <20181213042838.75160-1-sashal@kernel.org>
From: Kunihiko Hayashi <hayashi.kunihiko@socionext.com>
[ Upstream commit 88113957ddb7b7d5451e28cd708c82ea7e63b097 ]
In commit 26a4676faa1a ("arm64: mm: define NET_IP_ALIGN to 0"),
AVE controller affects this modification because the controller forces
to ignore lower 2bits of buffer start address, and make 2-byte headroom,
that is, data reception starts from (buffer + 2).
This patch defines AVE_FRAME_HEADROOM macro as hardware-specific value,
and replaces NET_IP_ALIGN with it.
Signed-off-by: Kunihiko Hayashi <hayashi.kunihiko@socionext.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
drivers/net/ethernet/socionext/sni_ave.c | 14 ++++++++------
1 file changed, 8 insertions(+), 6 deletions(-)
diff --git a/drivers/net/ethernet/socionext/sni_ave.c b/drivers/net/ethernet/socionext/sni_ave.c
index f7ecceeb1e28..f27d67a4d304 100644
--- a/drivers/net/ethernet/socionext/sni_ave.c
+++ b/drivers/net/ethernet/socionext/sni_ave.c
@@ -194,6 +194,7 @@
/* Parameter for ethernet frame */
#define AVE_MAX_ETHFRAME 1518
+#define AVE_FRAME_HEADROOM 2
/* Parameter for interrupt */
#define AVE_INTM_COUNT 20
@@ -585,12 +586,13 @@ static int ave_rxdesc_prepare(struct net_device *ndev, int entry)
skb = priv->rx.desc[entry].skbs;
if (!skb) {
- skb = netdev_alloc_skb_ip_align(ndev,
- AVE_MAX_ETHFRAME);
+ skb = netdev_alloc_skb(ndev, AVE_MAX_ETHFRAME);
if (!skb) {
netdev_err(ndev, "can't allocate skb for Rx\n");
return -ENOMEM;
}
+ skb->data += AVE_FRAME_HEADROOM;
+ skb->tail += AVE_FRAME_HEADROOM;
}
/* set disable to cmdsts */
@@ -603,12 +605,12 @@ static int ave_rxdesc_prepare(struct net_device *ndev, int entry)
* - Rx buffer begins with 2 byte headroom, and data will be put from
* (buffer + 2).
* To satisfy this, specify the address to put back the buffer
- * pointer advanced by NET_IP_ALIGN by netdev_alloc_skb_ip_align(),
- * and expand the map size by NET_IP_ALIGN.
+ * pointer advanced by AVE_FRAME_HEADROOM, and expand the map size
+ * by AVE_FRAME_HEADROOM.
*/
ret = ave_dma_map(ndev, &priv->rx.desc[entry],
- skb->data - NET_IP_ALIGN,
- AVE_MAX_ETHFRAME + NET_IP_ALIGN,
+ skb->data - AVE_FRAME_HEADROOM,
+ AVE_MAX_ETHFRAME + AVE_FRAME_HEADROOM,
DMA_FROM_DEVICE, &paddr);
if (ret) {
netdev_err(ndev, "can't map skb for Rx\n");
--
2.19.1
next prev parent reply other threads:[~2018-12-13 4:27 UTC|newest]
Thread overview: 32+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-12-13 4:27 [PATCH AUTOSEL 4.19 01/73] mac80211_hwsim: fix module init error paths for netlink Sasha Levin
2018-12-13 4:27 ` [PATCH AUTOSEL 4.19 06/73] tools/bpf: fix two test_btf unit test cases Sasha Levin
2018-12-13 4:27 ` [PATCH AUTOSEL 4.19 07/73] tools/bpf: add addition type tests to test_btf Sasha Levin
2018-12-13 4:27 ` Sasha Levin [this message]
2018-12-13 4:27 ` [PATCH AUTOSEL 4.19 09/73] net: phy: sfp: correct store of detected link modes Sasha Levin
2018-12-13 4:27 ` [PATCH AUTOSEL 4.19 20/73] net: stmmac: Move debugfs init/exit to ->probe()/->remove() Sasha Levin
2018-12-13 4:27 ` [PATCH AUTOSEL 4.19 21/73] net: aquantia: fix rx checksum offload bits Sasha Levin
2018-12-13 4:27 ` [PATCH AUTOSEL 4.19 22/73] bonding: fix 802.3ad state sent to partner when unbinding slave Sasha Levin
2018-12-13 4:27 ` [PATCH AUTOSEL 4.19 23/73] bpf: Fix verifier log string check for bad alignment Sasha Levin
2018-12-13 4:27 ` [PATCH AUTOSEL 4.19 24/73] liquidio: read sc->iq_no before release sc Sasha Levin
2018-12-13 4:27 ` [PATCH AUTOSEL 4.19 26/73] SUNRPC: Fix leak of krb5p encode pages Sasha Levin
2018-12-13 4:27 ` [PATCH AUTOSEL 4.19 27/73] SUNRPC: Fix a potential race in xprt_connect() Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 42/73] net: phy: don't allow __set_phy_supported to add unsupported modes Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 43/73] net: 8139cp: fix a BUG triggered by changing mtu with network traffic Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 44/73] net: phy: Fix not to call phy_resume() if PHY is not attached Sasha Levin
2018-12-13 4:48 ` Yoshihiro Shimoda
2018-12-19 13:43 ` Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 45/73] net: phy: micrel: add toggling phy reset " Sasha Levin
2018-12-13 4:44 ` Yoshihiro Shimoda
2018-12-19 13:43 ` Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 46/73] macvlan: return correct error value Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 47/73] mv88e6060: disable hardware level MAC learning Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 48/73] net/mlx4_en: Change min MTU size to ETH_MIN_MTU Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 49/73] net/mlx4_en: Fix build break when CONFIG_INET is off Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 50/73] bpf: check pending signals while verifying programs Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 54/73] ethernet: fman: fix wrong of_node_put() in probe function Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 56/73] net: mvpp2: fix detection of 10G SFP modules Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 57/73] net: mvpp2: fix phylink handling of invalid PHY modes Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 64/73] vhost/vsock: fix reset orphans race with close timeout Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 65/73] mlxsw: spectrum_switchdev: Fix VLAN device deletion via ioctl Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 72/73] Revert "net/ibm/emac: wrong bit is used for STA control" Sasha Levin
2018-12-13 4:28 ` [PATCH AUTOSEL 4.19 73/73] net/mlx4_core: Correctly set PFC param if global pause is turned off Sasha Levin
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20181213042838.75160-8-sashal@kernel.org \
--to=sashal@kernel.org \
--cc=davem@davemloft.net \
--cc=hayashi.kunihiko@socionext.com \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=stable@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).