[PATCH net 3/4] s390/qeth: cancel close_dev work before removing a card

[Julian Wiedmann <jwi@linux.ibm.com>]

A card's close_dev work is scheduled on a driver-wide workqueue. If the
card is removed and freed while the work is still active, this causes a
use-after-free.
So make sure that the work is completed before freeing the card.

Fixes: 0f54761d167f ("qeth: Support VEPA mode")
Signed-off-by: Julian Wiedmann <jwi@linux.ibm.com>
---
 drivers/s390/net/qeth_core.h    | 1 +
 drivers/s390/net/qeth_l2_main.c | 2 ++
 drivers/s390/net/qeth_l3_main.c | 1 +
 3 files changed, 4 insertions(+)

diff --git a/drivers/s390/net/qeth_core.h b/drivers/s390/net/qeth_core.h
index 0ee026947f20..1cf45ace0dd0 100644
--- a/drivers/s390/net/qeth_core.h
+++ b/drivers/s390/net/qeth_core.h
@@ -22,6 +22,7 @@
 #include <linux/hashtable.h>
 #include <linux/ip.h>
 #include <linux/refcount.h>
+#include <linux/workqueue.h>
 
 #include <net/ipv6.h>
 #include <net/if_inet6.h>
diff --git a/drivers/s390/net/qeth_l2_main.c b/drivers/s390/net/qeth_l2_main.c
index f108d4b44605..9fec0117fc00 100644
--- a/drivers/s390/net/qeth_l2_main.c
+++ b/drivers/s390/net/qeth_l2_main.c
@@ -801,6 +801,8 @@ static void qeth_l2_remove_device(struct ccwgroup_device *cgdev)
 
 	if (cgdev->state == CCWGROUP_ONLINE)
 		qeth_l2_set_offline(cgdev);
+
+	cancel_work_sync(&card->close_dev_work);
 	if (qeth_netdev_is_registered(card->dev))
 		unregister_netdev(card->dev);
 }
diff --git a/drivers/s390/net/qeth_l3_main.c b/drivers/s390/net/qeth_l3_main.c
index 42a7cdc59b76..5e810561cb12 100644
--- a/drivers/s390/net/qeth_l3_main.c
+++ b/drivers/s390/net/qeth_l3_main.c
@@ -2338,6 +2338,7 @@ static void qeth_l3_remove_device(struct ccwgroup_device *cgdev)
 	if (cgdev->state == CCWGROUP_ONLINE)
 		qeth_l3_set_offline(cgdev);
 
+	cancel_work_sync(&card->close_dev_work);
 	if (qeth_netdev_is_registered(card->dev))
 		unregister_netdev(card->dev);
 	qeth_l3_clear_ip_htable(card, 0);
-- 
2.16.4