* [PATCH net-next 1/2] net: marvell: mvpp2: use phy_interface_mode_is_8023z() helper
@ 2019-02-04 23:35 Russell King
2019-02-05 18:40 ` David Miller
0 siblings, 1 reply; 2+ messages in thread
From: Russell King @ 2019-02-04 23:35 UTC (permalink / raw)
To: Antoine Tenart, Maxime Chevallier; +Cc: Baruch Siach, David S. Miller, netdev
Use the phy_interface_mode_is_8023z() helper for detecting interface
modes that use 802.3z serial encoding. This is equivalent to testing
for both 1000base-X and 2500base-X.
Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
---
drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c | 38 ++++++++++---------------
1 file changed, 15 insertions(+), 23 deletions(-)
diff --git a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
index f1dab0b55769..c54ed19dcdae 100644
--- a/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
+++ b/drivers/net/ethernet/marvell/mvpp2/mvpp2_main.c
@@ -1090,9 +1090,8 @@ static void mvpp22_gop_unmask_irq(struct mvpp2_port *port)
u32 val;
if (phy_interface_mode_is_rgmii(port->phy_interface) ||
- port->phy_interface == PHY_INTERFACE_MODE_SGMII ||
- port->phy_interface == PHY_INTERFACE_MODE_1000BASEX ||
- port->phy_interface == PHY_INTERFACE_MODE_2500BASEX) {
+ phy_interface_mode_is_8023z(port->phy_interface) ||
+ port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
/* Enable the GMAC link status irq for this port */
val = readl(port->base + MVPP22_GMAC_INT_SUM_MASK);
val |= MVPP22_GMAC_INT_SUM_MASK_LINK_STAT;
@@ -1122,9 +1121,8 @@ static void mvpp22_gop_mask_irq(struct mvpp2_port *port)
}
if (phy_interface_mode_is_rgmii(port->phy_interface) ||
- port->phy_interface == PHY_INTERFACE_MODE_SGMII ||
- port->phy_interface == PHY_INTERFACE_MODE_1000BASEX ||
- port->phy_interface == PHY_INTERFACE_MODE_2500BASEX) {
+ phy_interface_mode_is_8023z(port->phy_interface) ||
+ port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
val = readl(port->base + MVPP22_GMAC_INT_SUM_MASK);
val &= ~MVPP22_GMAC_INT_SUM_MASK_LINK_STAT;
writel(val, port->base + MVPP22_GMAC_INT_SUM_MASK);
@@ -1136,9 +1134,8 @@ static void mvpp22_gop_setup_irq(struct mvpp2_port *port)
u32 val;
if (phy_interface_mode_is_rgmii(port->phy_interface) ||
- port->phy_interface == PHY_INTERFACE_MODE_SGMII ||
- port->phy_interface == PHY_INTERFACE_MODE_1000BASEX ||
- port->phy_interface == PHY_INTERFACE_MODE_2500BASEX) {
+ phy_interface_mode_is_8023z(port->phy_interface) ||
+ port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
val = readl(port->base + MVPP22_GMAC_INT_MASK);
val |= MVPP22_GMAC_INT_MASK_LINK_STAT;
writel(val, port->base + MVPP22_GMAC_INT_MASK);
@@ -1259,9 +1256,8 @@ static void mvpp2_port_loopback_set(struct mvpp2_port *port,
else
val &= ~MVPP2_GMAC_GMII_LB_EN_MASK;
- if (port->phy_interface == PHY_INTERFACE_MODE_SGMII ||
- port->phy_interface == PHY_INTERFACE_MODE_1000BASEX ||
- port->phy_interface == PHY_INTERFACE_MODE_2500BASEX)
+ if (phy_interface_mode_is_8023z(port->phy_interface) ||
+ port->phy_interface == PHY_INTERFACE_MODE_SGMII)
val |= MVPP2_GMAC_PCS_LB_EN_MASK;
else
val &= ~MVPP2_GMAC_PCS_LB_EN_MASK;
@@ -2487,9 +2483,8 @@ static irqreturn_t mvpp2_link_status_isr(int irq, void *dev_id)
link = true;
}
} else if (phy_interface_mode_is_rgmii(port->phy_interface) ||
- port->phy_interface == PHY_INTERFACE_MODE_SGMII ||
- port->phy_interface == PHY_INTERFACE_MODE_1000BASEX ||
- port->phy_interface == PHY_INTERFACE_MODE_2500BASEX) {
+ phy_interface_mode_is_8023z(port->phy_interface) ||
+ port->phy_interface == PHY_INTERFACE_MODE_SGMII) {
val = readl(port->base + MVPP22_GMAC_INT_STAT);
if (val & MVPP22_GMAC_INT_STAT_LINK) {
event = true;
@@ -4581,8 +4576,7 @@ static void mvpp2_gmac_config(struct mvpp2_port *port, unsigned int mode,
ctrl0 &= ~MVPP2_GMAC_PORT_TYPE_MASK;
ctrl2 &= ~(MVPP2_GMAC_PORT_RESET_MASK | MVPP2_GMAC_PCS_ENABLE_MASK);
- if (state->interface == PHY_INTERFACE_MODE_1000BASEX ||
- state->interface == PHY_INTERFACE_MODE_2500BASEX) {
+ if (phy_interface_mode_is_8023z(state->interface)) {
/* 1000BaseX and 2500BaseX ports cannot negotiate speed nor can
* they negotiate duplex: they are always operating with a fixed
* speed of 1000/2500Mbps in full duplex, so force 1000/2500
@@ -4602,9 +4596,8 @@ static void mvpp2_gmac_config(struct mvpp2_port *port, unsigned int mode,
if (phylink_test(state->advertising, Asym_Pause))
an |= MVPP2_GMAC_FC_ADV_ASM_EN;
- if (state->interface == PHY_INTERFACE_MODE_SGMII ||
- state->interface == PHY_INTERFACE_MODE_1000BASEX ||
- state->interface == PHY_INTERFACE_MODE_2500BASEX) {
+ if (phy_interface_mode_is_8023z(state->interface) ||
+ state->interface == PHY_INTERFACE_MODE_SGMII) {
an |= MVPP2_GMAC_IN_BAND_AUTONEG;
ctrl2 |= MVPP2_GMAC_INBAND_AN_MASK | MVPP2_GMAC_PCS_ENABLE_MASK;
@@ -4665,9 +4658,8 @@ static void mvpp2_mac_config(struct net_device *dev, unsigned int mode,
if (state->interface == PHY_INTERFACE_MODE_10GKR)
mvpp2_xlg_config(port, mode, state);
else if (phy_interface_mode_is_rgmii(state->interface) ||
- state->interface == PHY_INTERFACE_MODE_SGMII ||
- state->interface == PHY_INTERFACE_MODE_1000BASEX ||
- state->interface == PHY_INTERFACE_MODE_2500BASEX)
+ phy_interface_mode_is_8023z(state->interface) ||
+ state->interface == PHY_INTERFACE_MODE_SGMII)
mvpp2_gmac_config(port, mode, state);
if (port->priv->hw_version == MVPP21 && port->flags & MVPP2_F_LOOPBACK)
--
2.7.4
^ permalink raw reply related [flat|nested] 2+ messages in thread
end of thread, other threads:[~2019-02-05 18:41 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2019-02-04 23:35 [PATCH net-next 1/2] net: marvell: mvpp2: use phy_interface_mode_is_8023z() helper Russell King
2019-02-05 18:40 ` David Miller
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).