netdev.vger.kernel.org archive mirror
 help / color / mirror / Atom feed
From: Marek Vasut <marex@denx.de>
To: netdev@vger.kernel.org
Cc: Marek Vasut <marex@denx.de>,
	"David S . Miller" <davem@davemloft.net>,
	Lukas Wunner <lukas@wunner.de>, Petr Stetiar <ynezz@true.cz>,
	YueHaibing <yuehaibing@huawei.com>
Subject: [PATCH 07/14] net: ks8851: Use 16-bit writes to program MAC address
Date: Tue, 24 Mar 2020 00:42:56 +0100	[thread overview]
Message-ID: <20200323234303.526748-8-marex@denx.de> (raw)
In-Reply-To: <20200323234303.526748-1-marex@denx.de>

On the SPI variant of KS8851, the MAC address can be programmed with
either 8/16/32-bit writes. To make it easier to support the 16-bit
parallel option of KS8851 too, switch both the MAC address programming
and readout to 16-bit operations.

Remove ks8851_wrreg8() as it is not used anywhere anymore.

There should be no functional change.

Signed-off-by: Marek Vasut <marex@denx.de>
Cc: David S. Miller <davem@davemloft.net>
Cc: Lukas Wunner <lukas@wunner.de>
Cc: Petr Stetiar <ynezz@true.cz>
Cc: YueHaibing <yuehaibing@huawei.com>
---
 drivers/net/ethernet/micrel/ks8851.c | 47 ++++++++--------------------
 1 file changed, 13 insertions(+), 34 deletions(-)

diff --git a/drivers/net/ethernet/micrel/ks8851.c b/drivers/net/ethernet/micrel/ks8851.c
index be9478f39009..3150f1b928c0 100644
--- a/drivers/net/ethernet/micrel/ks8851.c
+++ b/drivers/net/ethernet/micrel/ks8851.c
@@ -185,36 +185,6 @@ static void ks8851_wrreg16(struct ks8851_net *ks, unsigned reg, unsigned val)
 		netdev_err(ks->netdev, "spi_sync() failed\n");
 }
 
-/**
- * ks8851_wrreg8 - write 8bit register value to chip
- * @ks: The chip state
- * @reg: The register address
- * @val: The value to write
- *
- * Issue a write to put the value @val into the register specified in @reg.
- */
-static void ks8851_wrreg8(struct ks8851_net *ks, unsigned reg, unsigned val)
-{
-	struct spi_transfer *xfer = &ks->spi_xfer1;
-	struct spi_message *msg = &ks->spi_msg1;
-	__le16 txb[2];
-	int ret;
-	int bit;
-
-	bit = 1 << (reg & 3);
-
-	txb[0] = cpu_to_le16(MK_OP(bit, reg) | KS_SPIOP_WR);
-	txb[1] = val;
-
-	xfer->tx_buf = txb;
-	xfer->rx_buf = NULL;
-	xfer->len = 3;
-
-	ret = spi_sync(ks->spidev, msg);
-	if (ret < 0)
-		netdev_err(ks->netdev, "spi_sync() failed\n");
-}
-
 /**
  * ks8851_rdreg - issue read register command and return the data
  * @ks: The device state
@@ -349,6 +319,7 @@ static void ks8851_set_powermode(struct ks8851_net *ks, unsigned pwrmode)
 static int ks8851_write_mac_addr(struct net_device *dev)
 {
 	struct ks8851_net *ks = netdev_priv(dev);
+	u16 val;
 	int i;
 
 	mutex_lock(&ks->lock);
@@ -358,8 +329,12 @@ static int ks8851_write_mac_addr(struct net_device *dev)
 	 * the first write to the MAC address does not take effect.
 	 */
 	ks8851_set_powermode(ks, PMECR_PM_NORMAL);
-	for (i = 0; i < ETH_ALEN; i++)
-		ks8851_wrreg8(ks, KS_MAR(i), dev->dev_addr[i]);
+
+	for (i = 0; i < ETH_ALEN; i += 2) {
+		val = (dev->dev_addr[i] << 8) | dev->dev_addr[i + 1];
+		ks8851_wrreg16(ks, KS_MAR(i + 1), val);
+	}
+
 	if (!netif_running(dev))
 		ks8851_set_powermode(ks, PMECR_PM_SOFTDOWN);
 
@@ -377,12 +352,16 @@ static int ks8851_write_mac_addr(struct net_device *dev)
 static void ks8851_read_mac_addr(struct net_device *dev)
 {
 	struct ks8851_net *ks = netdev_priv(dev);
+	u16 reg;
 	int i;
 
 	mutex_lock(&ks->lock);
 
-	for (i = 0; i < ETH_ALEN; i++)
-		dev->dev_addr[i] = ks8851_rdreg8(ks, KS_MAR(i));
+	for (i = 0; i < ETH_ALEN; i += 2) {
+		reg = ks8851_rdreg16(ks, KS_MAR(i + 1));
+		dev->dev_addr[i] = reg & 0xff;
+		dev->dev_addr[i + 1] = reg >> 8;
+	}
 
 	mutex_unlock(&ks->lock);
 }
-- 
2.25.1


  parent reply	other threads:[~2020-03-23 23:43 UTC|newest]

Thread overview: 52+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2020-03-23 23:42 [PATCH 00/14] net: ks8851: Unify KS8851 SPI and MLL drivers Marek Vasut
2020-03-23 23:42 ` [PATCH 01/14] net: ks8851: Factor out spi->dev in probe()/remove() Marek Vasut
2020-03-24  1:15   ` Andrew Lunn
2020-03-24  6:46   ` Lukas Wunner
2020-03-23 23:42 ` [PATCH 02/14] net: ks8851: Replace dev_err() with netdev_err() in IRQ handler Marek Vasut
2020-03-24  1:16   ` Andrew Lunn
2020-03-23 23:42 ` [PATCH 03/14] net: ks8851: Pass device pointer into ks8851_init_mac() Marek Vasut
2020-03-24  1:06   ` Andrew Lunn
2020-03-24  7:08     ` Lukas Wunner
2020-03-23 23:42 ` [PATCH 04/14] net: ks8851: Use devm_alloc_etherdev() Marek Vasut
2020-03-24  1:19   ` Andrew Lunn
2020-03-23 23:42 ` [PATCH 05/14] net: ks8851: Use dev_{get,set}_drvdata() Marek Vasut
2020-03-24  1:22   ` Andrew Lunn
2020-03-23 23:42 ` [PATCH 06/14] net: ks8851: Remove ks8851_rdreg32() Marek Vasut
2020-03-24  1:30   ` Andrew Lunn
2020-03-24 12:34     ` Marek Vasut
2020-03-24  7:22   ` Lukas Wunner
2020-03-24 12:37     ` Marek Vasut
2020-03-23 23:42 ` Marek Vasut [this message]
2020-03-24  1:40   ` [PATCH 07/14] net: ks8851: Use 16-bit writes to program MAC address Andrew Lunn
2020-03-24  7:17   ` Michal Kubecek
2020-03-24  8:13   ` Lukas Wunner
2020-03-24 12:25     ` Andrew Lunn
2020-03-24 12:36       ` Lukas Wunner
2020-03-24 13:09         ` Marek Vasut
2020-03-24 13:31           ` Marek Vasut
2020-03-24 14:47           ` Lukas Wunner
2020-03-24 14:53             ` Marek Vasut
2020-03-23 23:42 ` [PATCH 08/14] net: ks8851: Use 16-bit read of RXFC register Marek Vasut
2020-03-24  1:50   ` Andrew Lunn
2020-03-24 12:50     ` Marek Vasut
2020-03-24 13:32       ` Andrew Lunn
2020-03-24 10:41   ` Lukas Wunner
2020-03-24 12:42     ` Marek Vasut
2020-03-23 23:42 ` [PATCH 09/14] net: ks8851: Split out SPI specific entries in struct ks8851_net Marek Vasut
2020-03-24  1:55   ` Andrew Lunn
2020-03-24 10:49   ` Lukas Wunner
2020-03-24 12:27     ` Andrew Lunn
2020-03-23 23:42 ` [PATCH 10/14] net: ks8851: Split out SPI specific code from probe() and remove() Marek Vasut
2020-03-24  1:58   ` Andrew Lunn
2020-03-23 23:43 ` [PATCH 11/14] net: ks8851: Implement register and FIFO accessor callbacks Marek Vasut
2020-03-24 13:45   ` Lukas Wunner
2020-03-24 14:10     ` Marek Vasut
2020-03-24 14:29       ` Lukas Wunner
2020-03-24 14:44         ` Marek Vasut
2020-03-29 14:22     ` Marek Vasut
2020-03-23 23:43 ` [PATCH 12/14] net: ks8851: Separate SPI operations into separate file Marek Vasut
2020-03-23 23:43 ` [PATCH 13/14] net: ks8851: Implement Parallel bus operations Marek Vasut
2020-03-24  8:16   ` kbuild test robot
2020-03-23 23:43 ` [PATCH 14/14] net: ks8851: Remove ks8851_mll.c Marek Vasut
2020-03-24 14:08   ` Lukas Wunner
2020-03-24 14:12     ` Marek Vasut

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20200323234303.526748-8-marex@denx.de \
    --to=marex@denx.de \
    --cc=davem@davemloft.net \
    --cc=lukas@wunner.de \
    --cc=netdev@vger.kernel.org \
    --cc=ynezz@true.cz \
    --cc=yuehaibing@huawei.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).