Re: [PATCH v1 1/3] net: phy: Allow mdio buses to auto-probe c45 devices

[Russell King - ARM Linux admin <linux@armlinux.org.uk>]

On Wed, Jun 17, 2020 at 08:51:20PM +0200, Andrew Lunn wrote:
> > > +	/* bus capabilities, used for probing */
> > > +	enum {
> > > +		MDIOBUS_C22 = 0,
> > > +		MDIOBUS_C45,
> > > +		MDIOBUS_C22_C45,
> > > +	} probe_capabilities;
> > 
> > I think it would be better to reserve "0" to mean that no capabilities
> > have been declared.  We hae the situation where we have mii_bus that
> > exist which do support C45, but as they stand, probe_capabilities will
> > be zero, and with your definitions above, that means MDIOBUS_C22.
> > 
> > It seems this could lock in some potential issues later down the line
> > if we want to use this elsewhere.
> 
> Hi Russell
> 
> Actually, this patch already causes issues, i think.
> 
> drivers/net/ethernet/marvell/mvmdio.c contains two MDIO bus master
> drivers. "marvell,orion-mdio" is C22 only. "marvell,xmdio" is C45
> only. Because the capabilites is not initialized, it will default to
> 0, aka MDIOBUS_C22, for the C45 only bus master, and i expect bad
> things will happen.
> 
> We need the value of 0 to cause existing behaviour. Or all MDIO bus
> drivers need reviewing, and the correct capabilities set.

Yes, that's basically what I was trying to say, thanks for putting it
more clearly.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!