[PATCH net-next] net: systemport: Add support for VLAN transmit acceleration

[Florian Fainelli <f.fainelli@gmail.com>]

SYSTEMPORT is capable of performing VLAN transmit acceleration, support
that by configuring it appropriately, providing the VLAN ID and PCP/DEI
where necessary.

Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
---
 drivers/net/ethernet/broadcom/bcmsysport.c | 37 ++++++++++++++++++++--
 1 file changed, 34 insertions(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/broadcom/bcmsysport.c b/drivers/net/ethernet/broadcom/bcmsysport.c
index b25356e21a1e..b470551bae4f 100644
--- a/drivers/net/ethernet/broadcom/bcmsysport.c
+++ b/drivers/net/ethernet/broadcom/bcmsysport.c
@@ -160,13 +160,26 @@ static void bcm_sysport_set_tx_csum(struct net_device *dev,
 	/* Hardware transmit checksum requires us to enable the Transmit status
 	 * block prepended to the packet contents
 	 */
-	priv->tsb_en = !!(wanted & (NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM));
+	priv->tsb_en = !!(wanted & (NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM |
+				    NETIF_F_HW_VLAN_CTAG_TX));
 	reg = tdma_readl(priv, TDMA_CONTROL);
 	if (priv->tsb_en)
 		reg |= tdma_control_bit(priv, TSB_EN);
 	else
 		reg &= ~tdma_control_bit(priv, TSB_EN);
+	/* Indicating that software inserts Broadcom tags is needed for the TX
+	 * checksum to be computed correctly when using VLAN HW acceleration,
+	 * else it has no effect, so it can always be turned on.
+	 */
+	if (netdev_uses_dsa(dev))
+		reg |= tdma_control_bit(priv, SW_BRCM_TAG);
+	else
+		reg &= ~tdma_control_bit(priv, SW_BRCM_TAG);
 	tdma_writel(priv, reg, TDMA_CONTROL);
+
+	/* Default TPID is ETH_P_8021AD, change to ETH_P_8021Q */
+	if (wanted & NETIF_F_HW_VLAN_CTAG_TX)
+		tdma_writel(priv, ETH_P_8021Q, TDMA_TPID);
 }
 
 static int bcm_sysport_set_features(struct net_device *dev,
@@ -1236,6 +1249,12 @@ static struct sk_buff *bcm_sysport_insert_tsb(struct sk_buff *skb,
 	/* Zero-out TSB by default */
 	memset(tsb, 0, sizeof(*tsb));
 
+	if (skb_vlan_tag_present(skb)) {
+		tsb->pcp_dei_vid = (skb_vlan_tag_get_prio(skb) >>
+				    VLAN_PRIO_SHIFT & PCP_DEI_MASK);
+		tsb->pcp_dei_vid |= (u32)skb_vlan_tag_get_id(skb) << VID_SHIFT;
+	}
+
 	if (skb->ip_summed == CHECKSUM_PARTIAL) {
 		ip_ver = skb->protocol;
 		switch (ip_ver) {
@@ -1251,6 +1270,9 @@ static struct sk_buff *bcm_sysport_insert_tsb(struct sk_buff *skb,
 
 		/* Get the checksum offset and the L4 (transport) offset */
 		csum_start = skb_checksum_start_offset(skb) - sizeof(*tsb);
+		/* Account for the HW inserted VLAN tag */
+		if (skb_vlan_tag_present(skb))
+			csum_start += VLAN_HLEN;
 		csum_info = (csum_start + skb->csum_offset) & L4_CSUM_PTR_MASK;
 		csum_info |= (csum_start << L4_PTR_SHIFT);
 
@@ -1330,6 +1352,8 @@ static netdev_tx_t bcm_sysport_xmit(struct sk_buff *skb,
 		       DESC_STATUS_SHIFT;
 	if (skb->ip_summed == CHECKSUM_PARTIAL)
 		len_status |= (DESC_L4_CSUM << DESC_STATUS_SHIFT);
+	if (skb_vlan_tag_present(skb))
+		len_status |= (TX_STATUS_VLAN_VID_TSB << DESC_STATUS_SHIFT);
 
 	ring->curr_desc++;
 	if (ring->curr_desc == ring->size)
@@ -1503,7 +1527,13 @@ static int bcm_sysport_init_tx_ring(struct bcm_sysport_priv *priv,
 		reg |= RING_IGNORE_STATUS;
 	}
 	tdma_writel(priv, reg, TDMA_DESC_RING_MAPPING(index));
-	tdma_writel(priv, 0, TDMA_DESC_RING_PCP_DEI_VID(index));
+	reg = 0;
+	/* Adjust the packet size calculations if SYSTEMPORT is responsible
+	 * for HW insertion of VLAN tags
+	 */
+	if (priv->netdev->features & NETIF_F_HW_VLAN_CTAG_TX)
+		reg = VLAN_HLEN << RING_PKT_SIZE_ADJ_SHIFT;
+	tdma_writel(priv, reg, TDMA_DESC_RING_PCP_DEI_VID(index));
 
 	/* Enable ACB algorithm 2 */
 	reg = tdma_readl(priv, TDMA_CONTROL);
@@ -2523,7 +2553,8 @@ static int bcm_sysport_probe(struct platform_device *pdev)
 	netif_napi_add(dev, &priv->napi, bcm_sysport_poll, 64);
 
 	dev->features |= NETIF_F_RXCSUM | NETIF_F_HIGHDMA |
-			 NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM;
+			 NETIF_F_IP_CSUM | NETIF_F_IPV6_CSUM |
+			 NETIF_F_HW_VLAN_CTAG_TX;
 	dev->hw_features |= dev->features;
 	dev->vlan_features |= dev->features;
 
-- 
2.17.1