[net PATCH 2/2] net: dsa: qca8k: fix MTU calculation

[Ansuel Smith <ansuelsmth@gmail.com>]

From: Robert Marko <robert.marko@sartura.hr>

qca8k has a global MTU, so its tracking the MTU per port to make sure
that the largest MTU gets applied.
Since it uses the frame size instead of MTU the driver MTU change function
will then add the size of Ethernet header and checksum on top of MTU.

The driver currently populates the per port MTU size as Ethernet frame
length + checksum which equals 1518.

The issue is that then MTU change function will go through all of the
ports, find the largest MTU and apply the Ethernet header + checksum on
top of it again, so for a desired MTU of 1500 you will end up with 1536.

This is obviously incorrect, so to correct it populate the per port struct
MTU with just the MTU and not include the Ethernet header + checksum size
as those will be added by the MTU change function.

Fixes: f58d2598cf70 ("net: dsa: qca8k: implement the port MTU callbacks")
Signed-off-by: Robert Marko <robert.marko@sartura.hr>
Signed-off-by: Ansuel Smith <ansuelsmth@gmail.com>
---
 drivers/net/dsa/qca8k.c | 6 +++++-
 1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/net/dsa/qca8k.c b/drivers/net/dsa/qca8k.c
index d7bcecbc1c53..147ca39531a3 100644
--- a/drivers/net/dsa/qca8k.c
+++ b/drivers/net/dsa/qca8k.c
@@ -1256,8 +1256,12 @@ qca8k_setup(struct dsa_switch *ds)
 		/* Set initial MTU for every port.
 		 * We have only have a general MTU setting. So track
 		 * every port and set the max across all port.
+		 * Set per port MTU to 1500 as the MTU change function
+		 * will add the overhead and if its set to 1518 then it
+		 * will apply the overhead again and we will end up with
+		 * MTU of 1536 instead of 1518
 		 */
-		priv->port_mtu[i] = ETH_FRAME_LEN + ETH_FCS_LEN;
+		priv->port_mtu[i] = ETH_DATA_LEN;
 	}
 
 	/* Special GLOBAL_FC_THRESH value are needed for ar8327 switch */
-- 
2.32.0