Re: [PATCH v2] net: macb: Restart tx only if queue pointer is lagging

[Jakub Kicinski <kuba@kernel.org>]

On Thu,  7 Apr 2022 19:16:59 +0300 Tomas Melin wrote:
> commit 4298388574da ("net: macb: restart tx after tx used bit read")
> added support for restarting transmission. Restarting tx does not work
> in case controller asserts TXUBR interrupt and TQBP is already at the end
> of the tx queue. In that situation, restarting tx will immediately cause
> assertion of another TXUBR interrupt. The driver will end up in an infinite
> interrupt loop which it cannot break out of.
> 
> For cases where TQBP is at the end of the tx queue, instead
> only clear TX_USED interrupt. As more data gets pushed to the queue,
> transmission will resume.
> 
> This issue was observed on a Xilinx Zynq-7000 based board.
> During stress test of the network interface,
> driver would get stuck on interrupt loop within seconds or minutes
> causing CPU to stall.
> 
> Signed-off-by: Tomas Melin <tomas.melin@vaisala.com>

Applied, thanks. Commit 5ad7f18cd82c ("net: macb: Restart tx only if
queue pointer is lagging") in net.