[PATCH 1/2] dt-bindings: dp83867: define ti,ledX-active-low properties

[Rasmus Villemoes <linux@rasmusvillemoes.dk>]

The dp83867 has three LED_X pins that can be used to drive LEDs. They
are by default driven active high, but on some boards the reverse is
needed. Add bindings to allow a board to specify that they should be
active low.

Signed-off-by: Rasmus Villemoes <linux@rasmusvillemoes.dk>
---
 .../devicetree/bindings/net/ti,dp83867.yaml       | 15 +++++++++++++++
 1 file changed, 15 insertions(+)

diff --git a/Documentation/devicetree/bindings/net/ti,dp83867.yaml b/Documentation/devicetree/bindings/net/ti,dp83867.yaml
index b8c0e4b5b494..8483544e28c3 100644
--- a/Documentation/devicetree/bindings/net/ti,dp83867.yaml
+++ b/Documentation/devicetree/bindings/net/ti,dp83867.yaml
@@ -118,6 +118,21 @@ properties:
       Transmitt FIFO depth- see dt-bindings/net/ti-dp83867.h for applicable
       values.
 
+  ti,led0-active-low:
+    type: boolean
+    description: |
+      This denotes that the LED_0 pin should be driven as active low.
+
+  ti,led1-active-low:
+    type: boolean
+    description: |
+      This denotes that the LED_1 pin should be driven as active low.
+
+  ti,led2-active-low:
+    type: boolean
+    description: |
+      This denotes that the LED_2 pin should be driven as active low.
+
 required:
   - reg
 
-- 
2.37.2