Re: [PATCH net-next v5 4/4] phy: aquantia: Determine rate adaptation support from registers

[Vladimir Oltean <olteanv@gmail.com>]

On Thu, Jan 05, 2023 at 05:46:48PM +0000, Russell King (Oracle) wrote:
> On Thu, Jan 05, 2023 at 07:34:45PM +0200, Vladimir Oltean wrote:
> > So we lose the advertisement of 5G and 2.5G, even if the firmware is
> > provisioned for them via 10GBASE-R rate adaptation, right? Because when
> > asked "What kind of rate matching is supported for 10GBASE-R?", the
> > Aquantia driver will respond "None".
> 
> The code doesn't have the ability to do any better right now - since
> we don't know what sets of interface modes _could_ be used by the PHY
> and whether each interface mode may result in rate adaption.
> 
> To achieve that would mean reworking yet again all the phylink
> validation from scratch, and probably reworking phylib and most of
> the PHY drivers too so that they provide a lot more information
> about their host interface behaviour.
> 
> I don't think there is an easy way to have a "perfect" solution
> immediately - it's going to take a while to evolve - and probably
> painfully evolve due to the slowness involved in updating all the
> drivers that make use of phylink in some way.

Serious question. What do we gain in practical terms with this patch set
applied? With certain firmware provisioning, some unsupported link modes
won't be advertised anymore. But also, with other firmware, some supported
link modes won't be advertised anymore.

IIUC, Tim Harvey's firmware ultimately had incorrect provisioning, it's
not like the existing code prevents his use case from working.