[RFC/RFTv3 08/24] net: stmmac: Drop usage of phy_init_eee()

[Andrew Lunn <andrew@lunn.ch>]

Replace this method by looking at the eee_active member of the phydev
structure. Additionally, call the phy_eee_clk_stop_enable() if the
platform indicates the clock should be stopped while LPI is active.

Signed-off-by: Andrew Lunn <andrew@lunn.ch>
---
 drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 17310ade88dd..dd2488998993 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -1080,8 +1080,9 @@ static void stmmac_mac_link_up(struct phylink_config *config,
 
 	stmmac_mac_set(priv, priv->ioaddr, true);
 	if (phy && priv->dma_cap.eee) {
-		priv->eee_active =
-			phy_init_eee(phy, !priv->plat->rx_clk_runs_in_lpi) >= 0;
+		priv->eee_active = phy->eee_active;
+		if (!priv->plat->rx_clk_runs_in_lpi)
+			phy_eee_clk_stop_enable(phy);
 		priv->eee_enabled = stmmac_eee_init(priv);
 		priv->tx_lpi_enabled = priv->eee_enabled;
 		stmmac_set_eee_pls(priv, priv->hw, true);
-- 
2.40.0