[PATCH net-next v4 2/3] net: ethernet: cortina: Use negotiated TX/RX pause

[Linus Walleij <linus.walleij@linaro.org>]

Instead of directly poking into registers of the PHY, use
the existing function to query phylib about this directly.

Suggested-by: Andrew Lunn <andrew@lunn.ch>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
---
 drivers/net/ethernet/cortina/gemini.c | 15 +++++----------
 1 file changed, 5 insertions(+), 10 deletions(-)

diff --git a/drivers/net/ethernet/cortina/gemini.c b/drivers/net/ethernet/cortina/gemini.c
index ff3aeee15e5b..b33f9798471e 100644
--- a/drivers/net/ethernet/cortina/gemini.c
+++ b/drivers/net/ethernet/cortina/gemini.c
@@ -292,8 +292,8 @@ static void gmac_adjust_link(struct net_device *netdev)
 	struct gemini_ethernet_port *port = netdev_priv(netdev);
 	struct phy_device *phydev = netdev->phydev;
 	union gmac_status status, old_status;
-	int pause_tx = 0;
-	int pause_rx = 0;
+	bool pause_tx = false;
+	bool pause_rx = false;
 
 	status.bits32 = readl(port->gmac_base + GMAC_STATUS);
 	old_status.bits32 = status.bits32;
@@ -328,14 +328,9 @@ static void gmac_adjust_link(struct net_device *netdev)
 	}
 
 	if (phydev->duplex == DUPLEX_FULL) {
-		u16 lcladv = phy_read(phydev, MII_ADVERTISE);
-		u16 rmtadv = phy_read(phydev, MII_LPA);
-		u8 cap = mii_resolve_flowctrl_fdx(lcladv, rmtadv);
-
-		if (cap & FLOW_CTRL_RX)
-			pause_rx = 1;
-		if (cap & FLOW_CTRL_TX)
-			pause_tx = 1;
+		phy_get_pause(phydev, &pause_tx, &pause_rx);
+		netdev_dbg(netdev, "set negotiated pause params pause TX = %s, pause RX = %s\n",
+			   pause_tx ? "ON" : "OFF", pause_rx ? "ON" : "OFF");
 	}
 
 	gmac_set_flow_control(netdev, pause_tx, pause_rx);

-- 
2.45.1