[PATCH v3 net-next] net: dsa: ksz_common: Allow only up to two HSR HW offloaded ports for KSZ9477

[Lukasz Majewski <lukma@denx.de>]

The KSZ9477 allows HSR in-HW offloading for any of two selected ports.
This patch adds check if one tries to use more than two ports with
HSR offloading enabled.

The problem is with RedBox configuration (HSR-SAN) - when configuring:
ip link add name hsr0 type hsr slave1 lan1 slave2 lan2 interlink lan3 \
	supervision 45 version 1

The lan1 (port0) and lan2 (port1) are correctly configured as ports, which
can use HSR offloading on ksz9477.

However, when we do already have two bits set in hsr_ports, we need to
return (-ENOTSUPP), so the interlink port (lan3) would be used with
SW based HSR RedBox support.

Otherwise, I do see some strange network behavior, as some HSR frames are
visible on non-HSR network and vice versa.

This causes the switch connected to interlink port (lan3) to drop frames
and no communication is possible.

Moreover, conceptually - the interlink (i.e. HSR-SAN port - lan3/port2)
shall be only supported in software as it is also possible to use ksz9477
with only SW based HSR (i.e. port0/1 -> hsr0 with offloading, port2 ->
HSR-SAN/interlink, port4/5 -> hsr1 with SW based HSR).

Fixes: 5055cccfc2d1 ("net: hsr: Provide RedBox support (HSR-SAN)")
Signed-off-by: Lukasz Majewski <lukma@denx.de>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Reviewed-by: Dan Carpenter <dan.carpenter@linaro.org>

---
Changes for v2:
- Add more verbose description with Fixes: tag
- Check the condition earlier and remove extra check if SoC is ksz9477
- Add comment in the source code file

Changes for v3:
- Change 'use' to 'using'
- Adjust commit subject prefix
---
 drivers/net/dsa/microchip/ksz_common.c | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/drivers/net/dsa/microchip/ksz_common.c b/drivers/net/dsa/microchip/ksz_common.c
index 2818e24e2a51..debb554b60ed 100644
--- a/drivers/net/dsa/microchip/ksz_common.c
+++ b/drivers/net/dsa/microchip/ksz_common.c
@@ -3906,6 +3906,13 @@ static int ksz_hsr_join(struct dsa_switch *ds, int port, struct net_device *hsr,
 		return -EOPNOTSUPP;
 	}
 
+	/* KSZ9477 can only perform HSR offloading for up to two ports */
+	if (hweight8(dev->hsr_ports) >= 2) {
+		NL_SET_ERR_MSG_MOD(extack,
+				   "Cannot offload more than two ports - using software HSR");
+		return -EOPNOTSUPP;
+	}
+
 	/* Self MAC address filtering, to avoid frames traversing
 	 * the HSR ring more than once.
 	 */
-- 
2.20.1