Re: [PATCH 1/1] dt-bindings: net: mdio: Add negative patten match for child node

[Simon Horman <horms@kernel.org>]

On Sun, Aug 11, 2024 at 11:11:14PM -0400, Frank Li wrote:
> mdio.yaml wrong parser mdio controller's address instead phy's address when
> mdio-mux exist.
> 
> For example:
> mdio-mux-emi1@54 {
> 	compatible = "mdio-mux-mmioreg", "mdio-mux";
> 
>         mdio@20 {
> 		reg = <0x20>;
> 		       ^^^ This is mdio controller register
> 
> 		ethernet-phy@2 {
> 			reg = <0x2>;
>                               ^^^ This phy's address
> 		};
> 	};
> };
> 
> Only phy's address is limited to 31 because MDIO bus defination.

nit: definition

Also, in subject: patten -> pattern

Flagged by checkpatch.pl --codespell

> But CHECK_DTBS report below warning:
> 
> arch/arm64/boot/dts/freescale/fsl-ls1043a-qds.dtb: mdio-mux-emi1@54:
> 	mdio@20:reg:0:0: 32 is greater than the maximum of 31
> 
> The reason is that "mdio@20" match "patternProperties: '@[0-9a-f]+$'" in
> mdio.yaml.
> 
> Change to '^(?!mdio@).*@[0-9a-f]+$' to avoid match parent's mdio
> controller's address.
> 
> Signed-off-by: Frank Li <Frank.Li@nxp.com>

...