[PATCH net-next 3/4] net: xilinx: axienet: Don't print if we go into promiscuous mode

[Sean Anderson <sean.anderson@linux.dev>]

A message about being in promiscuous mode is printed every time each
additional multicast address beyond four is added. Suppress this message
like is done in other drivers. And don't set IFF_PROMISC in ndev->flags;
contrary to the comment we don't have to inform the net subsystem.

Signed-off-by: Sean Anderson <sean.anderson@linux.dev>
---

 drivers/net/ethernet/xilinx/xilinx_axienet_main.c | 7 -------
 1 file changed, 7 deletions(-)

diff --git a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
index 1bcabb016ca9..9bcad515f156 100644
--- a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
+++ b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
@@ -439,15 +439,9 @@ static void axienet_set_multicast_list(struct net_device *ndev)
 
 	if (ndev->flags & (IFF_ALLMULTI | IFF_PROMISC) ||
 	    netdev_mc_count(ndev) > XAE_MULTICAST_CAM_TABLE_NUM) {
-		/* We must make the kernel realize we had to move into
-		 * promiscuous mode. If it was a promiscuous mode request
-		 * the flag is already set. If not we set it.
-		 */
-		ndev->flags |= IFF_PROMISC;
 		reg = axienet_ior(lp, XAE_FMI_OFFSET);
 		reg |= XAE_FMI_PM_MASK;
 		axienet_iow(lp, XAE_FMI_OFFSET, reg);
-		dev_info(&ndev->dev, "Promiscuous mode enabled.\n");
 	} else if (!netdev_mc_empty(ndev)) {
 		struct netdev_hw_addr *ha;
 
@@ -481,7 +475,6 @@ static void axienet_set_multicast_list(struct net_device *ndev)
 		reg &= ~XAE_FMI_PM_MASK;
 
 		axienet_iow(lp, XAE_FMI_OFFSET, reg);
-		dev_info(&ndev->dev, "Promiscuous mode disabled.\n");
 	}
 
 	for (; i < XAE_MULTICAST_CAM_TABLE_NUM; i++) {
-- 
2.35.1.1320.gc452695387.dirty