From: Simon Horman <horms@kernel.org>
To: "Russell King (Oracle)" <rmk+kernel@armlinux.org.uk>
Cc: Andrew Lunn <andrew@lunn.ch>,
Heiner Kallweit <hkallweit1@gmail.com>,
Andrew Lunn <andrew+netdev@lunn.ch>,
Bryan Whitehead <bryan.whitehead@microchip.com>,
"David S. Miller" <davem@davemloft.net>,
Eric Dumazet <edumazet@google.com>,
Jakub Kicinski <kuba@kernel.org>,
Marcin Wojtas <marcin.s.wojtas@gmail.com>,
netdev@vger.kernel.org, Paolo Abeni <pabeni@redhat.com>,
UNGLinuxDriver@microchip.com
Subject: Re: [PATCH net-next 05/10] net: phylink: add EEE management
Date: Fri, 13 Dec 2024 09:37:09 +0000 [thread overview]
Message-ID: <20241213093709.GE2110@kernel.org> (raw)
In-Reply-To: <E1tKefi-006SMp-Hw@rmk-PC.armlinux.org.uk>
On Mon, Dec 09, 2024 at 02:23:38PM +0000, Russell King (Oracle) wrote:
> Add EEE management to phylink, making use of the phylib implementation.
> This will only be used where a MAC driver populates the methods and
> capabilities bitfield, otherwise we keep our old behaviour.
>
> Phylink will keep track of the EEE configuration, including the clock
> stop abilities at each end of the MAC to PHY link, programming the PHY
> appropriately and preserving the EEE configuration should the PHY go
> away.
>
> It will also call into the MAC driver when LPI needs to be enabled or
> disabled, with the expectation that the MAC have LPI disabled during
> probe.
>
> Support for phylink managed EEE is enabled by populating both tx_lpi
> MAC operations method pointers.
>
> Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
...
> diff --git a/include/linux/phylink.h b/include/linux/phylink.h
...
> @@ -143,11 +145,17 @@ enum phylink_op_type {
> * possible and avoid stopping it during suspend events.
> * @default_an_inband: if true, defaults to MLO_AN_INBAND rather than
> * MLO_AN_PHY. A fixed-link specification will override.
> + * @eee_rx_clk_stop_enable: if true, PHY can stop the receive clock during LPI
> * @get_fixed_state: callback to execute to determine the fixed link state,
> * if MAC link is at %MLO_AN_FIXED mode.
> * @supported_interfaces: bitmap describing which PHY_INTERFACE_MODE_xxx
> * are supported by the MAC/PCS.
> + * @lpi_interfaces: bitmap describing which PHY interface modes can support
> + * LPI signalling.
> * @mac_capabilities: MAC pause/speed/duplex capabilities.
> + * @lpi_capabilities: MAC speeds which can support LPI signalling
> + * @eee: default EEE configuration.
> + * @lpi_timer_limit_us: Maximum (inclusive) value of the EEE LPI timer.
> */
> struct phylink_config {
> struct device *dev;
> @@ -156,10 +164,16 @@ struct phylink_config {
> bool mac_managed_pm;
> bool mac_requires_rxc;
> bool default_an_inband;
> + bool eee_rx_clk_stop_enable;
> void (*get_fixed_state)(struct phylink_config *config,
> struct phylink_link_state *state);
> DECLARE_PHY_INTERFACE_MASK(supported_interfaces);
> + DECLARE_PHY_INTERFACE_MASK(lpi_interfaces);
> unsigned long mac_capabilities;
> + unsigned long lpi_capabilities;
> + u32 lpi_timer_limit_us;
> + u32 lpi_timer_default;
> + bool eee_enabled_default;
> };
Hi Russell,
A minor nit from my side.
The Kernel doc updates don't correspond entirely to the structure updates:
- @eee is documented but not present in the structure
- Conversely, @lpi_timer_default and @ee_enabled_default are
present in the structure but not documented.
...
next prev parent reply other threads:[~2024-12-13 9:37 UTC|newest]
Thread overview: 38+ messages / expand[flat|nested] mbox.gz Atom feed top
2024-12-09 14:22 [PATCH net-next 00/10] net: add phylink managed EEE support Russell King (Oracle)
2024-12-09 14:23 ` [PATCH net-next 01/10] net: mdio: add definition for clock stop capable bit Russell King (Oracle)
2024-12-10 2:21 ` Andrew Lunn
2024-12-09 14:23 ` [PATCH net-next 02/10] net: phy: add support for querying PHY clock stop capability Russell King (Oracle)
2024-12-10 3:00 ` Andrew Lunn
2024-12-09 14:23 ` [PATCH net-next 03/10] net: phy: add configuration of rx clock stop mode Russell King (Oracle)
2024-12-10 3:03 ` Andrew Lunn
2024-12-10 3:11 ` Andrew Lunn
2024-12-10 9:51 ` Russell King (Oracle)
2024-12-10 23:15 ` Andrew Lunn
2024-12-09 14:23 ` [PATCH net-next 04/10] net: phylink: add phylink_link_is_up() helper Russell King (Oracle)
2024-12-10 3:03 ` Andrew Lunn
2024-12-09 14:23 ` [PATCH net-next 05/10] net: phylink: add EEE management Russell King (Oracle)
2024-12-10 3:18 ` Andrew Lunn
2024-12-13 9:37 ` Simon Horman [this message]
2024-12-14 23:38 ` Heiner Kallweit
2025-01-02 16:39 ` Russell King (Oracle)
2024-12-09 14:23 ` [PATCH net-next 06/10] net: phylink: allow MAC driver to validate eee params Russell King (Oracle)
2024-12-10 3:21 ` Andrew Lunn
2024-12-10 9:58 ` Russell King (Oracle)
2024-12-10 13:58 ` Russell King (Oracle)
2024-12-09 14:23 ` [PATCH net-next 07/10] net: mvneta: convert to phylink EEE implementation Russell King (Oracle)
2024-12-10 3:25 ` Andrew Lunn
2024-12-13 10:04 ` Simon Horman
2024-12-13 10:22 ` Simon Horman
2024-12-13 10:51 ` Russell King (Oracle)
2024-12-09 14:23 ` [PATCH net-next 08/10] net: mvpp2: add " Russell King (Oracle)
2024-12-10 3:27 ` Andrew Lunn
2024-12-09 14:23 ` [PATCH net-next 09/10] net: lan743x: use netdev in lan743x_phylink_mac_link_down() Russell King (Oracle)
2024-12-10 3:28 ` Andrew Lunn
2024-12-09 14:24 ` [PATCH net-next 10/10] net: lan743x: convert to phylink managed EEE Russell King (Oracle)
2024-12-10 3:37 ` Andrew Lunn
2024-12-10 10:07 ` Russell King (Oracle)
2024-12-10 14:57 ` kernel test robot
2024-12-12 1:31 ` kernel test robot
2024-12-09 18:35 ` [PATCH net-next 00/10] net: add phylink managed EEE support Christian Marangi
2024-12-09 18:59 ` Russell King (Oracle)
2024-12-11 12:07 ` Russell King (Oracle)
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20241213093709.GE2110@kernel.org \
--to=horms@kernel.org \
--cc=UNGLinuxDriver@microchip.com \
--cc=andrew+netdev@lunn.ch \
--cc=andrew@lunn.ch \
--cc=bryan.whitehead@microchip.com \
--cc=davem@davemloft.net \
--cc=edumazet@google.com \
--cc=hkallweit1@gmail.com \
--cc=kuba@kernel.org \
--cc=marcin.s.wojtas@gmail.com \
--cc=netdev@vger.kernel.org \
--cc=pabeni@redhat.com \
--cc=rmk+kernel@armlinux.org.uk \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).