[PATCH v2 net] net: enetc: do not print error log if addr is 0

[Wei Fang <wei.fang@nxp.com>]

A value of 0 for addr indicates that the IEB_LBCR register does not
need to be configured, as its default value is 0. However, the driver
will print an error log if addr is 0, so this issue needs to be fixed.

Fixes: 50bfd9c06f0f ("net: enetc: set external PHY address in IERB for i.MX94 ENETC")
Signed-off-by: Wei Fang <wei.fang@nxp.com>
---
v2 changes:
Separate tests for "if (addr < 0)" and a later "if (!addr)".
v1: https://lore.kernel.org/imx/20251219082922.3883800-1-wei.fang@nxp.com/
---
 drivers/net/ethernet/freescale/enetc/netc_blk_ctrl.c | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/drivers/net/ethernet/freescale/enetc/netc_blk_ctrl.c b/drivers/net/ethernet/freescale/enetc/netc_blk_ctrl.c
index 443983fdecd9..7fd39f895290 100644
--- a/drivers/net/ethernet/freescale/enetc/netc_blk_ctrl.c
+++ b/drivers/net/ethernet/freescale/enetc/netc_blk_ctrl.c
@@ -577,11 +577,17 @@ static int imx94_enetc_mdio_phyaddr_config(struct netc_blk_ctrl *priv,
 	}
 
 	addr = netc_get_phy_addr(np);
-	if (addr <= 0) {
+	if (addr < 0) {
 		dev_err(dev, "Failed to get PHY address\n");
 		return addr;
 	}
 
+	/* The default value of LaBCR[MDIO_PHYAD_PRTAD] is 0,
+	 * so no need to set the register.
+	 */
+	if (!addr)
+		return 0;
+
 	if (phy_mask & BIT(addr)) {
 		dev_err(dev,
 			"Find same PHY address in EMDIO and ENETC node\n");
-- 
2.34.1