[PATCH] dt-bindings: net: dsa: fix typos in bindings docs

[Akiyoshi Kurita <weibu@redadmin.org>]

Fix "alway" -> "always" in lan9303.txt and marvell,mv88e6xxx.yaml.

Signed-off-by: Akiyoshi Kurita <weibu@redadmin.org>
---
 Documentation/devicetree/bindings/net/dsa/lan9303.txt         | 4 ++--
 .../devicetree/bindings/net/dsa/marvell,mv88e6xxx.yaml        | 4 ++--
 2 files changed, 4 insertions(+), 4 deletions(-)

diff --git a/Documentation/devicetree/bindings/net/dsa/lan9303.txt b/Documentation/devicetree/bindings/net/dsa/lan9303.txt
index 94f4f286cef9..46a732087f5c 100644
--- a/Documentation/devicetree/bindings/net/dsa/lan9303.txt
+++ b/Documentation/devicetree/bindings/net/dsa/lan9303.txt
@@ -16,9 +16,9 @@ Optional properties:
 Subnodes:
 
 The integrated switch subnode should be specified according to the binding
-described in dsa/dsa.txt. The CPU port of this switch is alway port 0.
+described in dsa/dsa.txt. The CPU port of this switch is always port 0.
 
-Note: alway use 'reg = <0/1/2>;' for the three DSA ports, even if the device is
+Note: always use 'reg = <0/1/2>;' for the three DSA ports, even if the device is
 configured to use 1/2/3 instead. This hardware configuration will be
 auto-detected and mapped accordingly.
 
diff --git a/Documentation/devicetree/bindings/net/dsa/marvell,mv88e6xxx.yaml b/Documentation/devicetree/bindings/net/dsa/marvell,mv88e6xxx.yaml
index 170d8b74f6cf..19ae600e9339 100644
--- a/Documentation/devicetree/bindings/net/dsa/marvell,mv88e6xxx.yaml
+++ b/Documentation/devicetree/bindings/net/dsa/marvell,mv88e6xxx.yaml
@@ -63,7 +63,7 @@ properties:
 
   interrupts:
     description: The switch provides an external interrupt line, but it is
-      not alway used by target systems.
+      not always used by target systems.
     maxItems: 1
 
   interrupt-controller:
@@ -72,7 +72,7 @@ properties:
 
   '#interrupt-cells':
     description: The internal interrupt controller only supports triggering
-      on active high level interrupts so the second cell must alway be set to
+      on active high level interrupts so the second cell must always be set to
       IRQ_TYPE_LEVEL_HIGH.
     const: 2
 
-- 
2.47.3