Re: [net-next,v2,07/22] net: stmmac: rk: convert to mask-based interface mode configuration

[Jakub Kicinski <kuba@kernel.org>]

This is an AI-generated review of your patch. The human sending this
email has considered the AI review valid, or at least plausible.

For local reproduction steps see https://netdev-ai.bots.linux.dev/ai-local.html
---
net: stmmac: rk: convert to mask-based interface mode configuration

This commit consolidates PHY interface mode configuration into common
infrastructure by introducing mask fields for phy_intf_sel and rmii_mode,
moving the register writes from SoC-specific functions into the common
rk_gmac_powerup() function.

> diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-rk.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-rk.c
> index 4117f6863ff0..35836ffdfc1d 100644

[ ... ]

> @@ -1654,7 +1685,9 @@ static int rk_gmac_check_ops(struct rk_priv_data *bsp_priv)
>  static int rk_gmac_powerup(struct rk_priv_data *bsp_priv)
>  {
>  	struct device *dev = bsp_priv->dev;
> +	u32 val;
>  	int ret;
> +	u8 intf;
>
>  	ret = rk_gmac_check_ops(bsp_priv);
>  	if (ret)
> @@ -1664,6 +1697,26 @@ static int rk_gmac_powerup(struct rk_priv_data *bsp_priv)
>  	if (ret)
>  		return ret;
>
> +	ret = rk_get_phy_intf_sel(bsp_priv->phy_iface);
> +	if (ret < 0)
> +		return ret;

Should this error path call gmac_clk_enable(bsp_priv, false) before
returning? The clocks were enabled just above, and the existing error
handling for rk_phy_powerup() later in this function disables the
clocks on failure:

    ret = rk_phy_powerup(bsp_priv);
    if (ret) {
        gmac_clk_enable(bsp_priv, false);
        return ret;
    }

> +
> +	intf = ret;
> +
> +	if (bsp_priv->gmac_phy_intf_sel_mask ||
> +	    bsp_priv->gmac_rmii_mode_mask) {
> +		/* If defined, encode the phy_intf_sel value */
> +		val = rk_encode_wm16(intf, bsp_priv->gmac_phy_intf_sel_mask);
> +
> +		/* If defined, encode the RMII mode mask setting. */
> +		val |= rk_encode_wm16(intf == PHY_INTF_SEL_RMII,
> +				      bsp_priv->gmac_rmii_mode_mask);
> +
> +		ret = regmap_write(bsp_priv->grf, bsp_priv->gmac_grf_reg, val);
> +		if (ret < 0)
> +			return ret;

Same question here - should this also disable clocks before returning?

> +	}