Re: [PATCH net-next] net: bcmgenet: enable EEE TX LPI by default

[Jakub Kicinski <kuba@kernel.org>]

On Mon, 16 Mar 2026 12:54:46 -0700 Florian Fainelli wrote:
> On 3/3/26 08:02, Nicolai Buchwitz wrote:
> > GENET never initializes priv->eee.eee_enabled or
> > priv->eee.tx_lpi_enabled to true, so the link-change callback in
> > bcmgenet_mac_config() always calls bcmgenet_eee_enable_set() with
> > enable=false.  The result is that EEE is negotiated at the PHY level
> > but the MAC never enters Low Power Idle, wasting the power savings
> > that EEE is designed to provide.
> > 
> > Users can work around this with 'ethtool --set-eee eth0 eee on tx-lpi
> > on tx-timer 250', but the MAC should enable TX LPI out of the box when
> > the hardware supports it, consistent with how phylink-managed MACs
> > behave (phylink calls phy_support_eee() which sets eee_enabled=true and
> > tx_lpi_enabled=true by default).
> > 
> > Initialize EEE software state during bcmgenet_open() on GENET v2+ so
> > that the link-change path activates EEE in hardware once the PHY
> > negotiates it.  Use an LPI timer of 250 us, matching the default used
> > by other MAC drivers (mvneta, mvpp2).
> > 
> > Signed-off-by: Nicolai Buchwitz <nb@tipi-net.de>  
> 
> Reviewed-by: Florian Fainelli <florian.fainelli@broadcom.com>

FWIW this patch is set to Changes Requested, I _think_ based on this
reply from Andrew:

https://lore.kernel.org/all/d352039f-4cbb-41e6-9aeb-0b4f3941b54c@lunn.ch/

LMK if the patch is good as is.