[PATCH net-next v5 3/3] riscv: dts: eswin: eic7700-hifive-premier-p550: enable Ethernet controller

[lizhi2@eswincomputing.com]

From: Zhi Li <lizhi2@eswincomputing.com>

Enable the on-board Gigabit Ethernet controller on the
HiFive Premier P550 development board.

Signed-off-by: Zhi Li <lizhi2@eswincomputing.com>
---
 .../dts/eswin/eic7700-hifive-premier-p550.dts | 42 ++++++++++++
 arch/riscv/boot/dts/eswin/eic7700.dtsi        | 66 +++++++++++++++++++
 2 files changed, 108 insertions(+)

diff --git a/arch/riscv/boot/dts/eswin/eic7700-hifive-premier-p550.dts b/arch/riscv/boot/dts/eswin/eic7700-hifive-premier-p550.dts
index 131ed1fc6b2e..5a40be1d2a25 100644
--- a/arch/riscv/boot/dts/eswin/eic7700-hifive-premier-p550.dts
+++ b/arch/riscv/boot/dts/eswin/eic7700-hifive-premier-p550.dts
@@ -13,6 +13,8 @@ / {
 
 	aliases {
 		serial0 = &uart0;
+		ethernet0 = &gmac0;
+		ethernet1 = &gmac1;
 	};
 
 	chosen {
@@ -20,6 +22,46 @@ chosen {
 	};
 };
 
+&gmac0 {
+	phy-handle = <&gmac0_phy0>;
+	phy-mode = "rgmii-id";
+	pinctrl-names = "default";
+	pinctrl-0 = <&gpio106_pins>;
+	rx-internal-delay-ps = <20>;
+	tx-internal-delay-ps = <100>;
+	status = "okay";
+
+	mdio {
+		gmac0_phy0: ethernet-phy@0 {
+			compatible = "ethernet-phy-id001c.c916";
+			reg = <0>;
+			reset-gpios = <&gpioD 10 GPIO_ACTIVE_LOW>;
+			reset-assert-us = <10000>;
+			reset-deassert-us = <80000>;
+		};
+	};
+};
+
+&gmac1 {
+	phy-handle = <&gmac1_phy0>;
+	phy-mode = "rgmii-rxid";
+	pinctrl-names = "default";
+	pinctrl-0 = <&gpio111_pins>;
+	rx-internal-delay-ps = <200>;
+	tx-internal-delay-ps = <200>;
+	status = "okay";
+
+	mdio {
+		gmac1_phy0: ethernet-phy@0 {
+			compatible = "ethernet-phy-id001c.c916";
+			reg = <0>;
+			reset-gpios = <&gpioD 15 GPIO_ACTIVE_LOW>;
+			reset-assert-us = <10000>;
+			reset-deassert-us = <80000>;
+		};
+	};
+};
+
 &uart0 {
 	status = "okay";
 };
diff --git a/arch/riscv/boot/dts/eswin/eic7700.dtsi b/arch/riscv/boot/dts/eswin/eic7700.dtsi
index c3ed93008bca..f1a01d5736a1 100644
--- a/arch/riscv/boot/dts/eswin/eic7700.dtsi
+++ b/arch/riscv/boot/dts/eswin/eic7700.dtsi
@@ -5,6 +5,8 @@
 
 /dts-v1/;
 
+#include <dt-bindings/gpio/gpio.h>
+
 / {
 	#address-cells = <2>;
 	#size-cells = <2>;
@@ -295,6 +297,70 @@ uart4: serial@50940000 {
 			status = "disabled";
 		};
 
+		gmac0: ethernet@50400000 {
+			compatible = "eswin,eic7700-qos-eth", "snps,dwmac-5.20";
+			reg = <0x0 0x50400000 0x0 0x10000>;
+			interrupts = <61>;
+			interrupt-names = "macirq";
+			clocks = <&clk 186>,
+				 <&clk 171>,
+				 <&clk 40>,
+				 <&clk 193>;
+			clock-names = "axi", "cfg", "stmmaceth", "tx";
+			resets = <&reset 95>;
+			reset-names = "stmmaceth";
+			eswin,hsp-sp-csr = <&hsp_sp_csr 0x100 0x108 0x118 0x114 0x11c>;
+			snps,aal;
+			snps,fixed-burst;
+			snps,tso;
+			snps,axi-config = <&stmmac_axi_setup_gmac0>;
+			status = "disabled";
+
+			stmmac_axi_setup_gmac0: stmmac-axi-config {
+				snps,blen = <0 0 0 0 16 8 4>;
+				snps,rd_osr_lmt = <2>;
+				snps,wr_osr_lmt = <2>;
+			};
+
+			mdio {
+				compatible = "snps,dwmac-mdio";
+				#address-cells = <1>;
+				#size-cells = <0>;
+			};
+		};
+
+		gmac1: ethernet@50410000 {
+			compatible = "eswin,eic7700-qos-eth-clk-inversion", "snps,dwmac-5.20";
+			reg = <0x0 0x50410000 0x0 0x10000>;
+			interrupts = <70>;
+			interrupt-names = "macirq";
+			clocks = <&clk 186>,
+				 <&clk 171>,
+				 <&clk 40>,
+				 <&clk 194>;
+			clock-names = "axi", "cfg", "stmmaceth", "tx";
+			resets = <&reset 94>;
+			reset-names = "stmmaceth";
+			eswin,hsp-sp-csr = <&hsp_sp_csr 0x200 0x208 0x218 0x214 0x21c>;
+			snps,aal;
+			snps,fixed-burst;
+			snps,tso;
+			snps,axi-config = <&stmmac_axi_setup_gmac1>;
+			status = "disabled";
+
+			stmmac_axi_setup_gmac1: stmmac-axi-config {
+				snps,blen = <0 0 0 0 16 8 4>;
+				snps,rd_osr_lmt = <2>;
+				snps,wr_osr_lmt = <2>;
+			};
+
+			mdio {
+				compatible = "snps,dwmac-mdio";
+				#address-cells = <1>;
+				#size-cells = <0>;
+			};
+		};
+
 		gpio@51600000 {
 			compatible = "snps,dw-apb-gpio";
 			reg = <0x0 0x51600000 0x0 0x80>;
-- 
2.25.1