[PATCH iwl-next v2 0/3] igc: add support for forcing link speed without autonegotiation

[KhaiWenTan <khai.wen.tan@linux.intel.com>]

From: Faizal Rahim <faizal.abdul.rahim@linux.intel.com>

This series adds support for forcing 10/100 Mb/s link speed via ethtool
when autonegotiation is disabled on the igc driver.

Changes in v2:
- Simon Horman's review comment: when forcing half-duplex, set
  hw->fc.requested_mode = igc_fc_none, since half-duplex cannot support
  flow control per IEEE 802.3.
- Split the original single patch into three patches for clarity:
  patches 1 and 2 are preparatory cleanups; patch 3 carries the
  functional change.

v1 at:
https://patchwork.ozlabs.org/project/intel-wired-lan/patch/20260409072747.217836-1-khai.wen.tan@linux.intel.com/

Faizal Rahim (3):
  igc: remove unused autoneg_failed field
  igc: move autoneg-enabled settings into igc_handle_autoneg_enabled()
  igc: add support for forcing link speed without autonegotiation

 drivers/net/ethernet/intel/igc/igc_base.c    |  35 +++-
 drivers/net/ethernet/intel/igc/igc_defines.h |   9 +-
 drivers/net/ethernet/intel/igc/igc_ethtool.c | 203 +++++++++++++------
 drivers/net/ethernet/intel/igc/igc_hw.h      |  10 +-
 drivers/net/ethernet/intel/igc/igc_mac.c     |  16 +-
 drivers/net/ethernet/intel/igc/igc_main.c    |   2 +-
 drivers/net/ethernet/intel/igc/igc_phy.c     |  65 +++++-
 drivers/net/ethernet/intel/igc/igc_phy.h     |   1 +
 8 files changed, 251 insertions(+), 90 deletions(-)

--
2.43.0