Re: [PATCH v3] net: phy: air_en8811h: add AN8811HB MCU assert/deassert support

[Jakub Kicinski <kuba@kernel.org>]

Since you need to repost to fix the fixes tag, plaese also improve the
error handling

On Mon, 20 Apr 2026 21:45:06 +0800 Lucien.Jheng wrote:
>  static int an8811hb_probe(struct phy_device *phydev)
>  {
> +	struct mdio_device *mdiodev;
>  	struct en8811h_priv *priv;
>  	int ret;
>  
> @@ -1175,10 +1281,22 @@ static int an8811hb_probe(struct phy_device *phydev)
>  		return -ENOMEM;
>  	phydev->priv = priv;
>  
> +	mdiodev = mdio_device_create(phydev->mdio.bus,
> +				     phydev->mdio.addr + EN8811H_PBUS_ADDR_OFFS);
> +	if (IS_ERR(mdiodev))
> +		return PTR_ERR(mdiodev);
> +
> +	ret = mdio_device_register(mdiodev);
> +	if (ret) {

goto err_dev_free;

> +		mdio_device_free(mdiodev);
> +		return ret;
> +	}
> +	priv->pbusdev = mdiodev;
> +
>  	ret = an8811hb_load_firmware(phydev);
>  	if (ret < 0) {
>  		phydev_err(phydev, "Load firmware failed: %d\n", ret);
> -		return ret;
> +		goto error;

goto err_dev_create;

>  	}
>  
>  	en8811h_print_fw_version(phydev);
> @@ -1191,22 +1309,27 @@ static int an8811hb_probe(struct phy_device *phydev)
>  
>  	ret = en8811h_leds_setup(phydev);
>  	if (ret < 0)
> -		return ret;
> +		goto error;
>  
>  	priv->phydev = phydev;
>  	/* Co-Clock Output */
>  	ret = an8811hb_clk_provider_setup(&phydev->mdio.dev, &priv->hw);
>  	if (ret)
> -		return ret;
> +		goto error;
>  
>  	/* Configure led gpio pins as output */
>  	ret = air_buckpbus_reg_modify(phydev, AN8811HB_GPIO_OUTPUT,
>  				      AN8811HB_GPIO_OUTPUT_345,
>  				      AN8811HB_GPIO_OUTPUT_345);
>  	if (ret < 0)
> -		return ret;
> +		goto error;
>  
>  	return 0;
> +
> +error:

err_dev_free:

> +	mdio_device_remove(priv->pbusdev);

err_dev_create:

> +	mdio_device_free(priv->pbusdev);
> +	return ret;