[PATCH iproute2-next v2 0/2] dpll: phase unit display and frequency monitoring

[Ivan Vecera <ivecera@redhat.com>]

This series improves dpll pin output formatting and adds support for
the frequency monitoring feature.

Patch 1 adds picosecond unit to phase-adjust-min, phase-adjust-max
and phase-adjust attributes. It also introduces the DPLL_PR_PHASE_OFFSET
macro that properly formats phase-offset as fractional picoseconds by
dividing the raw kernel value by DPLL_PHASE_OFFSET_DIVIDER.

Patch 2 adds support for the new frequency monitoring feature including
the DPLL_A_FREQUENCY_MONITOR device attribute and
DPLL_A_PIN_MEASURED_FREQUENCY pin attribute. The measured frequency is
displayed as fractional Hz using the DPLL_PR_MEASURED_FREQUENCY macro
since the kernel reports the value in millihertz. It also refactors
phase-offset-monitor parsing into a shared helper.

Tested on EDS2 development board with zl3073x DPLL:

  # dpll pin show package-label REF0P
  pin id 196:
    module-name: zl3073x
    clock-id: 13709406750444215013
    board-label: SyncE IN M1 CLK1
    package-label: REF0P
    type: synce-eth-port
    frequency: 125000000 Hz
    measured-frequency: 124999326.000 Hz
    frequency-supported:
      2500000 Hz
      25000000 Hz
      125000000 Hz
    capabilities: 0x6 state-can-change priority-can-change
    phase-adjust-min: -2147483648 ps
    phase-adjust-max: 2147483647 ps
    phase-adjust: 0 ps
    parent-device:
      id 14 direction input prio 10 state selectable phase-offset 0.000 ps
      id 15 direction input prio 0 state connected phase-offset 323.000 ps

Changes:
v2:
- fixed very long line in the man page

Ivan Vecera (2):
  dpll: add ps unit to phase-related pin attributes
  dpll: add frequency monitoring support

 bash-completion/dpll |  4 +-
 dpll/dpll.c          | 89 +++++++++++++++++++++++++++++++++++---------
 man/man8/dpll.8      | 19 +++++++++-
 3 files changed, 90 insertions(+), 22 deletions(-)

-- 
2.53.0