[PATCH net-next v12 5/7] net: stmmac: qcom-ethqos: reuse the address of ethqos_emac_driver_data

[Bartosz Golaszewski <bartosz.golaszewski@oss.qualcomm.com>]

Instead of needlessly copying the fields of ethqos_emac_driver_data into
struct qcom_ethqos, just use the address of the former as a reference.
It's .rodata after all. This is done in order to avoid having either two
calls to of_device_get_match_data() or having to extend the latter with
another field when adding support for SCMI.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski@oss.qualcomm.com>
---
 .../ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c    | 37 ++++++++--------------
 1 file changed, 14 insertions(+), 23 deletions(-)

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c
index 47b70b5e706f221c01f1c0ae3b1acafae6641165..fa3447b90315672d706d5ce7d710bdec6214e4e6 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-qcom-ethqos.c
@@ -103,12 +103,7 @@ struct qcom_ethqos {
 	struct clk *link_clk;
 	struct phy *serdes_phy;
 	phy_interface_t phy_mode;
-
-	const struct ethqos_emac_por *rgmii_por;
-	unsigned int num_rgmii_por;
-	bool rgmii_config_loopback_en;
-	bool has_emac_ge_3;
-	bool needs_sgmii_loopback;
+	const struct ethqos_emac_driver_data *data;
 };
 
 static u32 rgmii_readl(struct qcom_ethqos *ethqos, unsigned int offset)
@@ -189,7 +184,7 @@ static int ethqos_set_clk_tx_rate(void *bsp_priv, struct clk *clk_tx_i,
 static void
 qcom_ethqos_set_sgmii_loopback(struct qcom_ethqos *ethqos, bool enable)
 {
-	if (!ethqos->needs_sgmii_loopback ||
+	if (!ethqos->data->needs_sgmii_loopback ||
 	    ethqos->phy_mode != PHY_INTERFACE_MODE_2500BASEX)
 		return;
 
@@ -322,7 +317,7 @@ static int ethqos_dll_configure(struct qcom_ethqos *ethqos)
 	/* Set DLL_EN */
 	rgmii_setmask(ethqos, SDCC_DLL_CONFIG_DLL_EN, SDCC_HC_REG_DLL_CONFIG);
 
-	if (!ethqos->has_emac_ge_3) {
+	if (!ethqos->data->has_emac_ge_3) {
 		rgmii_clrmask(ethqos, SDCC_DLL_MCLK_GATING_EN,
 			      SDCC_HC_REG_DLL_CONFIG);
 
@@ -352,7 +347,7 @@ static int ethqos_dll_configure(struct qcom_ethqos *ethqos)
 	rgmii_setmask(ethqos, SDCC_DLL_CONFIG2_DDR_CAL_EN,
 		      SDCC_HC_REG_DLL_CONFIG2);
 
-	if (!ethqos->has_emac_ge_3) {
+	if (!ethqos->data->has_emac_ge_3) {
 		rgmii_clrmask(ethqos, SDCC_DLL_CONFIG2_DLL_CLOCK_DIS,
 			      SDCC_HC_REG_DLL_CONFIG2);
 
@@ -432,7 +427,7 @@ static int ethqos_rgmii_macro_init(struct qcom_ethqos *ethqos, int speed)
 	rgmii_clrmask(ethqos, RGMII_CONFIG2_RSVD_CONFIG15,
 		      RGMII_IO_MACRO_CONFIG2);
 
-	if (speed == SPEED_1000 || ethqos->has_emac_ge_3)
+	if (speed == SPEED_1000 || ethqos->data->has_emac_ge_3)
 		rgmii_setmask(ethqos, RGMII_CONFIG2_RX_PROG_SWAP,
 			      RGMII_IO_MACRO_CONFIG2);
 	else
@@ -456,7 +451,7 @@ static int ethqos_rgmii_macro_init(struct qcom_ethqos *ethqos, int speed)
 		 * in practice this becomes PRG_RCLK_DLY = 52 * 4 /
 		 *  (2 * RX delay ns)
 		 */
-		if (ethqos->has_emac_ge_3) {
+		if (ethqos->data->has_emac_ge_3) {
 			/* 0.9 ns */
 			prg_rclk_dly = 115;
 		} else {
@@ -472,7 +467,7 @@ static int ethqos_rgmii_macro_init(struct qcom_ethqos *ethqos, int speed)
 			      SDCC_HC_REG_DDR_CONFIG);
 	}
 
-	if (ethqos->rgmii_config_loopback_en)
+	if (ethqos->data->rgmii_config_loopback_en)
 		loopback = RGMII_CONFIG_LOOPBACK_EN;
 	else
 		loopback = 0;
@@ -495,9 +490,9 @@ static void ethqos_fix_mac_speed_rgmii(void *bsp_priv,
 	dev = &ethqos->pdev->dev;
 
 	/* Reset to POR values and enable clk */
-	for (i = 0; i < ethqos->num_rgmii_por; i++)
-		rgmii_writel(ethqos, ethqos->rgmii_por[i].value,
-			     ethqos->rgmii_por[i].offset);
+	for (i = 0; i < ethqos->data->num_rgmii_por; i++)
+		rgmii_writel(ethqos, ethqos->data->rgmii_por[i].value,
+			     ethqos->data->rgmii_por[i].offset);
 
 	ethqos_set_func_clk_en(ethqos);
 
@@ -511,7 +506,7 @@ static void ethqos_fix_mac_speed_rgmii(void *bsp_priv,
 	rgmii_setmask(ethqos, SDCC_DLL_CONFIG_PDN,
 		      SDCC_HC_REG_DLL_CONFIG);
 
-	if (ethqos->has_emac_ge_3) {
+	if (ethqos->data->has_emac_ge_3) {
 		if (speed == SPEED_1000) {
 			rgmii_writel(ethqos, 0x1800000, SDCC_TEST_CTL);
 			rgmii_writel(ethqos, 0x2C010800, SDCC_USR_CTL);
@@ -538,7 +533,7 @@ static void ethqos_fix_mac_speed_rgmii(void *bsp_priv,
 			      SDCC_HC_REG_DLL_CONFIG);
 
 		/* Set USR_CTL bit 26 with mask of 3 bits */
-		if (!ethqos->has_emac_ge_3)
+		if (!ethqos->data->has_emac_ge_3)
 			rgmii_updatel(ethqos, GENMASK(26, 24), BIT(26),
 				      SDCC_USR_CTL);
 
@@ -743,11 +738,7 @@ static int qcom_ethqos_probe(struct platform_device *pdev)
 				     "Failed to map rgmii resource\n");
 
 	data = of_device_get_match_data(dev);
-	ethqos->rgmii_por = data->rgmii_por;
-	ethqos->num_rgmii_por = data->num_rgmii_por;
-	ethqos->rgmii_config_loopback_en = data->rgmii_config_loopback_en;
-	ethqos->has_emac_ge_3 = data->has_emac_ge_3;
-	ethqos->needs_sgmii_loopback = data->needs_sgmii_loopback;
+	ethqos->data = data;
 
 	ethqos->link_clk = devm_clk_get(dev, data->link_clk_name ?: "rgmii");
 	if (IS_ERR(ethqos->link_clk))
@@ -784,7 +775,7 @@ static int qcom_ethqos_probe(struct platform_device *pdev)
 	plat_dat->dump_debug_regs = rgmii_dump;
 	plat_dat->ptp_clk_freq_config = ethqos_ptp_clk_freq_config;
 	plat_dat->core_type = DWMAC_CORE_GMAC4;
-	if (ethqos->has_emac_ge_3)
+	if (data->has_emac_ge_3)
 		plat_dat->dwmac4_addrs = &data->dwmac4_addrs;
 	plat_dat->pmt = true;
 	if (of_property_read_bool(np, "snps,tso"))

-- 
2.47.3