From: Michael Bommarito <michael.bommarito@gmail.com>
To: "David S . Miller" <davem@davemloft.net>,
Eric Dumazet <edumazet@google.com>,
Jakub Kicinski <kuba@kernel.org>, Paolo Abeni <pabeni@redhat.com>
Cc: Antoine Tenart <atenart@kernel.org>,
Simon Horman <horms@kernel.org>,
Tom Herbert <tom@herbertland.com>,
netdev@vger.kernel.org, linux-kernel@vger.kernel.org,
stable@vger.kernel.org
Subject: [PATCH net v2] ila: reload IPv6 header after pskb_may_pull in checksum adjust
Date: Tue, 14 Jul 2026 07:49:03 -0400 [thread overview]
Message-ID: <20260714114903.3763420-1-michael.bommarito@gmail.com> (raw)
ila_csum_adjust_transport() caches ip6h = ipv6_hdr(skb) before calling
pskb_may_pull(). On a non-linear skb whose transport header sits in a page
fragment, pskb_may_pull() can call __pskb_pull_tail() / pskb_expand_head()
and free the old skb head, leaving ip6h dangling; the following
get_csum_diff(ip6h, p) then reads freed memory. ila_update_ipv6_locator()
uses ip6h (and the iaddr derived from it) again after the csum-adjust
call and additionally writes the new locator through that pointer.
Impact: a remote IPv6 packet routed through a configured ILA
csum-adjust-transport route or receive-side mapping triggers a
slab-use-after-free in ila_update_ipv6_locator() (KASAN). The route or
mapping requires CAP_NET_ADMIN to configure, but trigger packets are
unauthenticated once it exists.
Reload ip6h after each pskb_may_pull() in ila_csum_adjust_transport()
before the csum-diff read. In ila_update_ipv6_locator() only the
ILA_CSUM_ADJUST_TRANSPORT case pulls the skb, so reload ip6h and iaddr in
that case alone before the destination-address write; the neutral-map
modes never pull and keep their cached pointers.
Fixes: 33f11d16142b ("ila: Create net/ipv6/ila directory")
Cc: stable@vger.kernel.org
Assisted-by: Claude:claude-opus-4-8
Signed-off-by: Michael Bommarito <michael.bommarito@gmail.com>
---
v2: In ila_update_ipv6_locator() reload ip6h/iaddr only in the
ILA_CSUM_ADJUST_TRANSPORT case instead of unconditionally, per
Antoine Tenart's review; the neutral-map modes never pull the skb,
so their cached pointers remain valid.
v1: https://lore.kernel.org/netdev/20260711150648.2915106-1-michael.bommarito@gmail.com/
Evidence: a KUnit case on UML+KASAN drives ila_update_ipv6_locator()
with a non-linear skb whose transport header sits in a fragment, so the
pskb_may_pull() in ila_csum_adjust_transport() reallocates the head.
Stock: BUG: KASAN: slab-use-after-free in ila_update_ipv6_locator, Read of
size 4 (the stale ip6h/iaddr). Patched: both the valid-linear control and
the fragmented case pass, KASAN-clean. Built clean, no new warnings.
net/ipv6/ila/ila_common.c | 12 ++++++++++++
1 file changed, 12 insertions(+)
diff --git a/net/ipv6/ila/ila_common.c b/net/ipv6/ila/ila_common.c
index e71571455c8a0..b78179bfc4c72 100644
--- a/net/ipv6/ila/ila_common.c
+++ b/net/ipv6/ila/ila_common.c
@@ -85,6 +85,7 @@ static void ila_csum_adjust_transport(struct sk_buff *skb,
struct tcphdr *th = (struct tcphdr *)
(skb_network_header(skb) + nhoff);
+ ip6h = ipv6_hdr(skb);
diff = get_csum_diff(ip6h, p);
inet_proto_csum_replace_by_diff(&th->check, skb,
diff, true, true);
@@ -96,6 +97,7 @@ static void ila_csum_adjust_transport(struct sk_buff *skb,
(skb_network_header(skb) + nhoff);
if (uh->check || skb->ip_summed == CHECKSUM_PARTIAL) {
+ ip6h = ipv6_hdr(skb);
diff = get_csum_diff(ip6h, p);
inet_proto_csum_replace_by_diff(&uh->check, skb,
diff, true, true);
@@ -110,6 +112,7 @@ static void ila_csum_adjust_transport(struct sk_buff *skb,
struct icmp6hdr *ih = (struct icmp6hdr *)
(skb_network_header(skb) + nhoff);
+ ip6h = ipv6_hdr(skb);
diff = get_csum_diff(ip6h, p);
inet_proto_csum_replace_by_diff(&ih->icmp6_cksum, skb,
diff, true, true);
@@ -127,6 +130,15 @@ void ila_update_ipv6_locator(struct sk_buff *skb, struct ila_params *p,
switch (p->csum_mode) {
case ILA_CSUM_ADJUST_TRANSPORT:
ila_csum_adjust_transport(skb, p);
+ /*
+ * ila_csum_adjust_transport() calls pskb_may_pull(), which can
+ * reallocate the skb head and leave ip6h (and the iaddr derived
+ * from it) dangling; reload both before the write below. The
+ * other csum modes do not pull, so their cached pointers stay
+ * valid.
+ */
+ ip6h = ipv6_hdr(skb);
+ iaddr = ila_a2i(&ip6h->daddr);
break;
case ILA_CSUM_NEUTRAL_MAP:
if (sir2ila) {
--
2.53.0
reply other threads:[~2026-07-14 11:49 UTC|newest]
Thread overview: [no followups] expand[flat|nested] mbox.gz Atom feed
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20260714114903.3763420-1-michael.bommarito@gmail.com \
--to=michael.bommarito@gmail.com \
--cc=atenart@kernel.org \
--cc=davem@davemloft.net \
--cc=edumazet@google.com \
--cc=horms@kernel.org \
--cc=kuba@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=pabeni@redhat.com \
--cc=stable@vger.kernel.org \
--cc=tom@herbertland.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox