[PATCH net-next] octeontx2-pf: report port connector type in ethtool link ksettings

[Ratheesh Kannoth <rkannoth@marvell.com>]

From: Hariprasad Kelam <hkelam@marvell.com>

otx2_get_link_ksettings() already fills speed, duplex, autoneg, link
modes and FEC from CGX firmware data, but leaves cmd->base.port unset.
As a result, ethtool does not show the physical connector type even
though the firmware provides it in fwdata.port.

Populate cmd->base.port from rsp->fwdata.port so users can see values
such as PORT_TP or PORT_AUI via ethtool.

Signed-off-by: Hariprasad Kelam <hkelam@marvell.com>
Signed-off-by: Ratheesh Kannoth <rkannoth@marvell.com>
---
 drivers/net/ethernet/marvell/octeontx2/nic/otx2_ethtool.c | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/drivers/net/ethernet/marvell/octeontx2/nic/otx2_ethtool.c b/drivers/net/ethernet/marvell/octeontx2/nic/otx2_ethtool.c
index 9bee1b91eeaa..65630de43539 100644
--- a/drivers/net/ethernet/marvell/octeontx2/nic/otx2_ethtool.c
+++ b/drivers/net/ethernet/marvell/octeontx2/nic/otx2_ethtool.c
@@ -1231,6 +1231,8 @@ static int otx2_get_link_ksettings(struct net_device *netdev,
 				OTX2_MODE_SUPPORTED, cmd);
 	otx2_get_fec_info(rsp->fwdata.supported_fec,
 			  OTX2_MODE_SUPPORTED, cmd);
+
+	cmd->base.port = rsp->fwdata.port;
 	return 0;
 }
 
-- 
2.43.0