From: Simon Horman <horms@kernel.org>
To: Prasad Koya <prasad@arista.com>
Cc: netdev@vger.kernel.org, andrew+netdev@lunn.ch,
davem@davemloft.net, edumazet@kernel.org, kuba@kernel.org,
pabeni@redhat.com, linux-kernel@vger.kernel.org,
stable@vger.kernel.org
Subject: Re: [PATCH net] macvlan: fix allmulti reference counting in passthru mode
Date: Fri, 30 Oct 2026 10:15:35 +0000 [thread overview]
Message-ID: <20261030101535.GN257209@horms.kernel.org> (raw)
In-Reply-To: <20261027024635.366900-1-prasad@arista.com>
On Mon, Oct 26, 2026 at 07:46:35PM -0700, Prasad Koya wrote:
> Enabling allmulticast on a down passthru macvlan, bringing it up,
> then toggling allmulticast off and on can underflow the lower device's
> allmulti reference count.
>
> macvlan_change_rx_flags() only propagates IFF_ALLMULTI changes while
> the macvlan is up. However, the passthru path in macvlan_open() skips
> taking an allmulti reference when IFF_ALLMULTI is already set.
> Clearing allmulticast after opening the device therefore decrements
> a reference that was never taken. With no other allmulti users, the
> unsigned counter wraps from zero to UINT_MAX. The next increment
> fails with -EOVERFLOW and reports "allmulti touches roof".
>
Hi Prasad,
A Fixes tag should go here.
(No blank line between it and your Signed-off-by line).
There is no need to repost just to address this.
Replying with the Fixes tag should be sufficient.
> Signed-off-by: Prasad Koya <prasad@arista.com>
> ---
> Reproducer:
>
> #!/bin/bash
> set -euo pipefail
>
> ns=allmulti-test
> host=am-veth0
> peer=am-veth1
> mv=am-mv0
>
> cleanup()
> {
> ip netns del "$ns" 2>/dev/null || true
> }
> trap cleanup EXIT
>
> ip netns add "$ns"
> ip link add "$host" type veth peer name "$peer"
> ip link set "$peer" netns "$ns"
>
> ip link set "$host" up
> ip -n "$ns" link set lo up
> ip -n "$ns" link set "$peer" up
>
> ip -n "$ns" link add link "$peer" name "$mv" type macvlan mode passthru
>
> ip -n "$ns" link set dev "$mv" allmulticast on
> ip -n "$ns" link set dev "$mv" up
> ip -n "$ns" link set dev "$mv" allmulticast off
> ip -n "$ns" link set dev "$mv" allmulticast on
>
> drivers/net/macvlan.c | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
> diff --git a/drivers/net/macvlan.c b/drivers/net/macvlan.c
> index afad90b9222a..e20d587453d1 100644
> --- a/drivers/net/macvlan.c
> +++ b/drivers/net/macvlan.c
> @@ -643,6 +643,14 @@ static int macvlan_open(struct net_device *dev)
> if (err < 0)
> goto out;
> }
> + if (dev->flags & IFF_ALLMULTI) {
> + err = dev_set_allmulti(lowerdev, 1);
> + if (err < 0) {
> + if (!(vlan->flags & MACVLAN_FLAG_NOPROMISC))
> + dev_set_promiscuity(lowerdev, -1);
> + goto out;
> + }
> + }
> goto hash_add;
> }
>
> @@ -713,6 +721,8 @@ static int macvlan_stop(struct net_device *dev)
> dev_mc_unsync(lowerdev, dev);
>
> if (macvlan_passthru(vlan->port)) {
> + if (dev->flags & IFF_ALLMULTI)
> + dev_set_allmulti(lowerdev, -1);
> if (!(vlan->flags & MACVLAN_FLAG_NOPROMISC))
> dev_set_promiscuity(lowerdev, -1);
> goto hash_del;
>
> base-commit: 7076f684d5132e6a6145e1da2fa74771ecd052e5
> --
> 2.43.0
>
I'm unsure if it matters, but the order of initialisation of multicast and
promiscuity differs here from the non-pass-through case.
Overall I think the approach you have taken here is appropriate
as a minimal fix for net.
Reviewed-by: Simon Horman <horms@kernel.org>
But I do see that there is growing duplication of code in the
pass-through and non-pass-through paths. And I believe that
is due to the approach taken by the existing code of using
goto to control flow (other than for cleanup in error paths).
In the longer term I think it would be nice to address that.
I took a stab at that. Perhaps I'm overthinking things.
But, FWIIW, this is what I cam up with (compile tested only).
diff --git a/drivers/net/macvlan.c b/drivers/net/macvlan.c
index a48c9e662fe9..f2a3cf540e4e 100644
--- a/drivers/net/macvlan.c
+++ b/drivers/net/macvlan.c
@@ -631,24 +631,31 @@ static const struct header_ops macvlan_hard_header_ops = {
.parse_protocol = eth_header_parse_protocol,
};
-static int macvlan_open(struct net_device *dev)
+static int macvlan_should_set_promisc(struct net_device *dev)
{
struct macvlan_dev *vlan = netdev_priv(dev);
- struct net_device *lowerdev = vlan->lowerdev;
- int err;
- if (macvlan_passthru(vlan->port)) {
- if (!(vlan->flags & MACVLAN_FLAG_NOPROMISC)) {
- err = dev_set_promiscuity(lowerdev, 1);
- if (err < 0)
- goto out;
- }
- goto hash_add;
- }
+ if (macvlan_passthru(vlan->port))
+ return !(vlan->flags & MACVLAN_FLAG_NOPROMISC);
+
+ return dev->flags & IFF_PROMISC;
+}
+
+/* Initialise acceleration or add unicast address.
+ * Skipped for pass-through ports.
+ */
+static int macvlan_init_vlan(struct net_device *dev)
+{
+ struct macvlan_dev *vlan = netdev_priv(dev);
+ struct net_device *lowerdev;
+
+ if (macvlan_passthru(vlan->port))
+ return 0;
- err = -EADDRINUSE;
if (macvlan_addr_busy(vlan->port, dev->dev_addr))
- goto out;
+ return -EADDRINUSE;
+
+ lowerdev = vlan->lowerdev;
/* Attempt to populate accel_priv which is used to offload the L2
* forwarding requests for unicast packets.
@@ -661,40 +668,71 @@ static int macvlan_open(struct net_device *dev)
* populated we must add the unicast address to the lower device.
*/
if (IS_ERR_OR_NULL(vlan->accel_priv)) {
+ int err;
+
vlan->accel_priv = NULL;
err = dev_uc_add(lowerdev, dev->dev_addr);
if (err < 0)
- goto out;
+ return err;
+ }
+
+ return 0;
+}
+
+/* Clean up acceleration or remove unicast address.
+ * Skipped for pass-through ports.
+ */
+static void macvlan_uninit_vlan(struct net_device *dev)
+{
+ struct macvlan_dev *vlan = netdev_priv(dev);
+ struct net_device *lowerdev;
+
+ if (macvlan_passthru(vlan->port))
+ return;
+
+ lowerdev = vlan->lowerdev;
+
+ if (vlan->accel_priv) {
+ lowerdev->netdev_ops->ndo_dfwd_del_station(lowerdev,
+ vlan->accel_priv);
+ vlan->accel_priv = NULL;
+ } else {
+ dev_uc_del(lowerdev, dev->dev_addr);
}
+}
+
+static int macvlan_open(struct net_device *dev)
+{
+ struct macvlan_dev *vlan = netdev_priv(dev);
+ struct net_device *lowerdev;
+ int err;
+
+ err = macvlan_init_vlan(dev);
+ if (err)
+ return err;
+
+ lowerdev = vlan->lowerdev;
if (dev->flags & IFF_ALLMULTI) {
err = dev_set_allmulti(lowerdev, 1);
if (err < 0)
- goto del_unicast;
+ goto uninit;
}
- if (dev->flags & IFF_PROMISC) {
+ if (macvlan_should_set_promisc(dev)) {
err = dev_set_promiscuity(lowerdev, 1);
if (err < 0)
goto clear_multi;
}
-hash_add:
macvlan_hash_add(vlan);
return 0;
clear_multi:
if (dev->flags & IFF_ALLMULTI)
dev_set_allmulti(lowerdev, -1);
-del_unicast:
- if (vlan->accel_priv) {
- lowerdev->netdev_ops->ndo_dfwd_del_station(lowerdev,
- vlan->accel_priv);
- vlan->accel_priv = NULL;
- } else {
- dev_uc_del(lowerdev, dev->dev_addr);
- }
-out:
+uninit:
+ macvlan_uninit_vlan(dev);
return err;
}
@@ -712,21 +750,15 @@ static int macvlan_stop(struct net_device *dev)
dev_uc_unsync(lowerdev, dev);
dev_mc_unsync(lowerdev, dev);
- if (macvlan_passthru(vlan->port)) {
- if (!(vlan->flags & MACVLAN_FLAG_NOPROMISC))
- dev_set_promiscuity(lowerdev, -1);
- goto hash_del;
- }
-
if (dev->flags & IFF_ALLMULTI)
dev_set_allmulti(lowerdev, -1);
- if (dev->flags & IFF_PROMISC)
+ if (macvlan_should_set_promisc(dev))
dev_set_promiscuity(lowerdev, -1);
- dev_uc_del(lowerdev, dev->dev_addr);
+ if (!macvlan_passthru(vlan->port))
+ dev_uc_del(lowerdev, dev->dev_addr);
-hash_del:
macvlan_hash_del(vlan, !dev->dismantle);
return 0;
}
next prev parent reply other threads:[~2026-10-30 10:15 UTC|newest]
Thread overview: 6+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-10-27 2:46 [PATCH net] macvlan: fix allmulti reference counting in passthru mode Prasad Koya
2026-10-27 2:51 ` netdev-bot+sinfo
[not found] ` <CAKh1g56_WiP3gTMbcWkukb_tK9Fnun6NqLAQKWdU5o2ECL0veQ@mail.gmail.com>
2026-10-27 3:43 ` Prasad Koya
2026-10-30 10:10 ` patchwork-bot+netdevbpf
2026-10-30 10:15 ` Simon Horman [this message]
2026-10-30 17:07 ` Prasad Koya
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20261030101535.GN257209@horms.kernel.org \
--to=horms@kernel.org \
--cc=andrew+netdev@lunn.ch \
--cc=davem@davemloft.net \
--cc=edumazet@kernel.org \
--cc=kuba@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=pabeni@redhat.com \
--cc=prasad@arista.com \
--cc=stable@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox