From: Antonio Almeida <vexwek@gmail.com>
To: Jarek Poplawski <jarkao2@gmail.com>
Cc: Stephen Hemminger <shemminger@vyatta.com>,
netdev@vger.kernel.org, kaber@trash.net, davem@davemloft.net,
devik@cdi.cz, Eric Dumazet <dada1@cosmosbay.com>,
Vladimir Ivashchenko <hazard@francoudi.com>
Subject: Re: [PATCH iproute2] Re: HTB accuracy for high speed
Date: Thu, 28 May 2009 19:13:40 +0100 [thread overview]
Message-ID: <298f5c050905281113o10393c61ye3c0539d2b6efa20@mail.gmail.com> (raw)
In-Reply-To: <20090523073201.GA2766@ami.dom.local>
On Sat, May 23, 2009 at 8:32 AM, Jarek Poplawski wrote:
> Actually, from these two I was more interested in iproute2 more
> fitting the kernel version. :-((It should be enough to have at least
> tc compiled properly, I guess.)
I installed iproute2-ss090115 with the new patch but the results are
the same for my test scenery. HTB keeps sending 620Mbit/s when I
configure it's ceil to 555Mbit/s, with 800 bytes packets long.
> Btw.: if at any point you think this testing is too disturbing to you
> etc., feel free to stop this or delay in time as you like.
I'm working on this, don't worry. Since I have a traffic
generator/analyser, any modification you would make I can test it.
You're free to ask.
I've been looking inside htb source code. The granularity problem
could be in the use qdisc_rate_table or near that.
Antonio Almeida
next prev parent reply other threads:[~2009-05-28 18:13 UTC|newest]
Thread overview: 104+ messages / expand[flat|nested] mbox.gz Atom feed top
[not found] <298f5c050905150745p13dc226eia1ff50ffa8c4b300@mail.gmail.com>
2009-05-15 14:49 ` HTB accuracy for high speed Antonio Almeida
2009-05-15 18:12 ` Stephen Hemminger
2009-05-18 10:01 ` Antonio Almeida
2009-05-18 10:45 ` Jarek Poplawski
2009-05-18 12:27 ` Antonio Almeida
2009-05-18 12:32 ` Jarek Poplawski
2009-05-18 16:13 ` Stephen Hemminger
2009-05-18 18:03 ` Antonio Almeida
2009-05-18 22:02 ` Stephen Hemminger
2009-05-19 11:48 ` Antonio Almeida
2009-05-19 13:08 ` Antonio Almeida
2009-05-16 8:31 ` Jarek Poplawski
2009-05-18 10:39 ` Antonio Almeida
2009-05-18 11:14 ` Jarek Poplawski
2009-05-18 12:05 ` Antonio Almeida
2009-05-16 14:14 ` Jarek Poplawski
2009-05-18 14:36 ` Antonio Almeida
2009-05-18 23:14 ` Vladimir Ivashchenko
2009-05-18 23:27 ` Vladimir Ivashchenko
2009-05-19 11:03 ` Jarek Poplawski
2009-05-19 14:04 ` Vladimir Ivashchenko
2009-05-19 20:10 ` Jarek Poplawski
2009-05-20 22:07 ` Vladimir Ivashchenko
2009-05-20 22:46 ` Eric Dumazet
2009-05-21 7:20 ` Jarek Poplawski
2009-05-21 7:44 ` Vladimir Ivashchenko
2009-05-21 8:28 ` Jarek Poplawski
2009-05-21 9:07 ` Eric Dumazet
2009-05-21 9:22 ` Jarek Poplawski
2009-05-23 10:37 ` HTB accuracy for high speed (and bonding) Vladimir Ivashchenko
2009-05-23 14:34 ` Jarek Poplawski
2009-05-23 15:06 ` Vladimir Ivashchenko
2009-05-23 15:35 ` Jarek Poplawski
2009-05-23 15:53 ` Vladimir Ivashchenko
2009-05-23 16:02 ` Jarek Poplawski
2009-05-18 16:40 ` HTB accuracy for high speed Eric Dumazet
2009-05-18 17:23 ` Jarek Poplawski
2009-05-18 21:52 ` David Miller
2009-05-18 23:59 ` [PATCH] pkt_sched: gen_estimator: use 64 bits intermediate counters for bps Eric Dumazet
2009-05-19 2:27 ` David Miller
2009-05-19 7:02 ` Jarek Poplawski
2009-05-19 7:31 ` Eric Dumazet
2009-05-19 7:42 ` Jarek Poplawski
2009-05-19 7:57 ` Jarek Poplawski
2009-05-19 18:03 ` Eric Dumazet
2009-05-19 19:09 ` [PATCH] pkt_sched: gen_estimator: Fix signed integers right-shifts Jarek Poplawski
2009-05-26 5:47 ` David Miller
2009-05-19 8:18 ` [PATCH] pkt_sched: gen_estimator: use 64 bits intermediate counters for bps David Miller
2009-05-17 20:15 ` HTB accuracy for high speed Jarek Poplawski
2009-05-18 6:56 ` [PATCH iproute2] " Jarek Poplawski
2009-05-18 16:54 ` Antonio Almeida
2009-05-18 17:16 ` Antonio Almeida
2009-05-21 8:51 ` Jarek Poplawski
2009-05-22 17:42 ` Antonio Almeida
2009-05-23 7:32 ` Jarek Poplawski
2009-05-28 18:13 ` Antonio Almeida [this message]
2009-05-28 21:12 ` Jarek Poplawski
2009-05-29 17:02 ` Antonio Almeida
2009-05-29 17:28 ` Stephen Hemminger
2009-05-29 19:58 ` Jarek Poplawski
2009-05-29 19:46 ` Jarek Poplawski
2009-05-29 20:49 ` Stephen Hemminger
2009-05-29 20:59 ` Jarek Poplawski
2009-05-30 20:07 ` Jarek Poplawski
2009-06-02 10:12 ` Antonio Almeida
2009-06-02 11:45 ` Antonio Almeida
2009-06-02 12:36 ` Jarek Poplawski
2009-06-02 12:45 ` Patrick McHardy
2009-06-02 13:08 ` Jarek Poplawski
2009-06-02 13:20 ` Patrick McHardy
2009-06-02 21:37 ` Jarek Poplawski
2009-06-02 21:50 ` Jarek Poplawski
2009-06-03 7:06 ` Patrick McHardy
2009-06-03 7:40 ` Jarek Poplawski
2009-06-03 7:53 ` Patrick McHardy
2009-06-03 8:01 ` Jarek Poplawski
2009-06-03 8:29 ` Patrick McHardy
2009-06-03 8:45 ` Jarek Poplawski
2009-06-03 9:54 ` Jarek Poplawski
2009-06-03 10:01 ` Patrick McHardy
2009-06-03 10:05 ` Patrick McHardy
2009-06-03 10:06 ` Patrick McHardy
2009-06-03 10:27 ` Jarek Poplawski
2009-06-04 13:50 ` Antonio Almeida
[not found] ` <20090604193013.GA2755@ami.dom.local>
[not found] ` <4A282216.20203@trash.net>
[not found] ` <20090604194203.GB2755@ami.dom.local>
2009-06-09 5:25 ` Badalian Vyacheslav
2009-06-09 5:49 ` Jarek Poplawski
2009-06-04 4:53 ` David Miller
2009-06-04 7:50 ` Jarek Poplawski
2009-05-18 17:53 ` Jarek Poplawski
2009-05-18 18:23 ` Antonio Almeida
2009-05-18 18:32 ` Jarek Poplawski
2009-05-18 18:56 ` Antonio Almeida
2009-05-18 19:05 ` Jarek Poplawski
2009-05-19 10:55 ` Antonio Almeida
2009-05-19 11:04 ` Denys Fedoryschenko
2009-05-19 11:18 ` Jarek Poplawski
2009-05-19 11:21 ` Denys Fedoryschenko
2009-05-19 11:28 ` Jarek Poplawski
2009-05-19 14:31 ` Antonio Almeida
2009-05-19 11:09 ` Jarek Poplawski
2009-05-19 13:18 ` Jesper Dangaard Brouer
2009-05-19 19:35 ` Jarek Poplawski
2009-05-18 7:01 ` [PATCH iproute2 v2] " Jarek Poplawski
2009-05-17 20:29 ` Vladimir Ivashchenko
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=298f5c050905281113o10393c61ye3c0539d2b6efa20@mail.gmail.com \
--to=vexwek@gmail.com \
--cc=dada1@cosmosbay.com \
--cc=davem@davemloft.net \
--cc=devik@cdi.cz \
--cc=hazard@francoudi.com \
--cc=jarkao2@gmail.com \
--cc=kaber@trash.net \
--cc=netdev@vger.kernel.org \
--cc=shemminger@vyatta.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).