Re: [EXPERIMENTAL PATCH] 2.4 tulip jumbo frames

[Ben Greear <greearb@candelatech.com>]

Rask Ingemann Lambertsen wrote:
> Attached is a patch which enables jumbo frames on tulip based boards. It  
> makes it possible to set an MTU of up to 2025 bytes. However, testing
> against an NE3200 board using 10base-2 shows assorted problems when going
> above 2018 bytes (for frames without VLAN tags). The problems show up as
> framing errors, bad CRCs and such (in both directions).
> 
> The patch is against 2.4.22-bk45.

> +static int tulip_change_mtu (struct net_device *dev, int mtu)
> +{
> +	if (netif_running (dev))
> +		return (-EBUSY);
> +
> +	if (mtu < 0 || mtu > PKT_BUF_SZ_MAX - VLAN_ETH_HLEN - 4)
> +		return (-EINVAL);

I suppose you could let them ignore the VLAN_ETH_HLEN if you
really wanted to (in case they are not running VLANs).

But, this should work fine too.

--Ben

> +
> +	dev->mtu = mtu;
> +	return (0);
> +}
> +

-- 
Ben Greear <greearb@candelatech.com>
Candela Technologies Inc  http://www.candelatech.com